Standard Ignition Fuel Injector P/N:FJ348
Standard Motor Products
Standard Ignition FJ1167 fuel injector for the 2008-2013 BMW 128i 6-cylinder 3.0L and other vehicles sprays metered fuel into the engine for combustion. It is a new, engine-specific injector with a plug-in connector.
A worn or clogged injector can show up as a rough idle, hesitation or poor fuel economy, though other faults can produce similar symptoms. Before replacing anything, look over the connector and the O-ring area with the engine off and cool for cracks, wetness or fuel residue; a shop can test spray pattern and flow. If a failed injector is the cause, this one replaces it.
This top-feed fuel injector is an OE replacement for the 2007-2013 BMW 328i 6-cylinder 3.0L and the 2009-2013 BMW 328i xDrive 6-cylinder 3.0L, along with other BMW models. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One fuel injector with its O-rings and seal. The 6-cylinder 3.0L takes six, so this listing covers one of them. Hardware is not included, and the old hardware may not be reusable, so plan on new pieces.
Interchange: 2-39234 · 800-2203N
13537574376 · 67774
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a BMW 328i fuel injector for the 2007-2013 6-cylinder 3.0L?
Yes. Standard Ignition FJ1167 fits the 2007-2013 BMW 328i 6-cylinder 3.0L. Open the "Vehicles it fits" section to check other models and engines.
Do the O-rings come with this Standard Ignition fuel injector?
Yes, the injector comes with its O-rings and a seal. Mounting hardware is not included.
What kind of connector does the FJ1167 injector use?
Standard Ignition FJ1167 has two male blade terminals and attaches with a plug-in connector.
What can a worn top-feed injector cause?
A worn injector can mean a rough idle, hesitation or poor fuel economy, though other faults give similar symptoms. A shop can test spray pattern and flow.
Is this injector calibrated for the engine?
Yes. It is end-of-line tested and calibrated, and its engine-specific metering discs are laser-drilled to set fuel flow rate and spray pattern.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.