Standard Ignition Fuel Injector P/N:FJ712
Standard Motor Products
Standard Ignition FJ619 fuel injector for the 1982-1985 Mercedes-Benz 300CD 5-cylinder 3.0L and other vehicles sprays diesel fuel directly into the cylinder. This Standard Ignition fuel injector is remanufactured for direct-injection diesel engines.
A worn injector can show up as hard starting, a rough idle or a fuel smell, and other fuel-system faults can produce similar symptoms. Before replacing it, look over the injector area and fuel lines for wetness or leaks with the engine off and cool, and leave spray and flow testing to a shop. These engines take five injectors, one per cylinder, and this listing is one injector.
This injector is listed for a wide range of Mercedes-Benz models, including the 1982-1985 Mercedes-Benz 300D 5-cylinder 3.0L and the 1978-1985 Mercedes-Benz 300SD 5-cylinder 3.0L. If your car is not named here, look for it in the "Vehicles it fits" section.
Fit and size
Build and materials
One fuel injector with new o-rings, copper seals and an instruction sheet.
Interchange: 800-1631
49225 · INJ800R · 0010170121 · 002017012160 · 002017012180 · 002017012188 · 0020172021 · 002017202180 · 002017202188 · 10170121
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this fuel injector right for a 1982-1985 Mercedes-Benz 300CD 5-cylinder 3.0L?
Yes, Standard Ignition FJ619 is listed for the 1982-1985 Mercedes-Benz 300CD with the 5-cylinder 3.0L engine, and the other listed models are in the "Vehicles it fits" section.
Are 300D fuel injectors like the FJ619 listed for the 1982-1985 Mercedes-Benz 300D 5-cylinder 3.0L?
Yes. FJ619 is listed for the 1982-1985 Mercedes-Benz 300D with the 5-cylinder 3.0L engine, and that engine takes five injectors.
Does the FJ619 diesel injector come with new o-rings and seals?
Yes. It comes with new o-rings, copper seals and an instruction sheet.
Is this fuel injector new or remanufactured?
Standard Ignition FJ619 is remanufactured: each injector is inspected, disassembled, validated, cleaned and reassembled with new O-rings, springs, nozzles, delivery valves, shims, gaskets and solenoids.
Is this diesel injector flow tested before it is packed?
Yes. It is calibrated to OE specification and checked on the flow bench to validate OE fuel flow, then packed with anti-corrosion fluid in a sealed VCI bag.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.