Standard Ignition Headlight Dimmer Switch Connector,Headlight Switch Connector P/N:S-606
Standard Motor Products
Replace a burnt, corroded or broken plug at the headlight dimmer switch with the Standard Ignition switch connector S-726. This Headlight Dimmer Switch Connector, also listed as a Headlight Switch Connector, links the vehicle wiring to the dimmer switch. It is a direct replacement for many vehicles, including the 1988-1994 Chevrolet C1500 and 1987-1995 Jeep Wrangler. See the "Vehicles it fits" section for the full list.
The connector draws on decades of Standard Ignition research and development focused on what technicians need. It is designed to address the inherent failure issues of the original equipment. If a melted, corroded or loose connector is behind flickering headlights or a dimmer switch that won't change beams, this connector replaces it. Check the switch and the wiring as well, since they can cause similar symptoms.
Interchange: PT5656 · 578 · EC164 · 12101927
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does the Standard Ignition S-726 do?
It is a headlight dimmer switch connector, also listed as a headlight switch connector. It links the vehicle wiring to the headlight dimmer switch.
Will it fit my 1987-1995 Jeep Wrangler switch harness?
Yes. The 1987-1995 Jeep Wrangler is one of the listed applications. The "Vehicles it fits" section shows the full list of the many vehicles it fits.
What are signs this connector may need replacing?
Signs include melted, burnt or corroded terminals, a loose fit, or headlights that flicker or won't switch beams. Diagnose the circuit first, because the switch or the wiring can cause the same symptoms.
Do I need special tools to install it?
Standard Ignition describes it as a factory-assembled connector designed to install without specialized tools. Follow the vehicle service information for the wiring repair.
How is the connector's quality controlled?
Standard Ignition builds its connectors to OE standards in facilities certified to TS16949 and ISO9001. Each one gets quality checks and testing at every stage of production.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.