Standard Ignition Ignition Coil Connector,Ignition Control Module Connector P/N:S-544
Standard Motor Products
Give your ignition coil or ignition control module a sound connection to the wiring harness with the Standard Ignition S-1533 Ignition Coil Connector / Ignition Control Module Connector. It is a direct-fit replacement for many vehicles, among them the 1999-2015 Volkswagen Jetta, 1997-2016 Audi A4 and 2005-2009 Chevrolet Cobalt. This part is also listed in the catalog as a wiper motor connector.
The connector plugs onto the component and joins it to the vehicle's wiring harness, carrying the electrical signal between the two.
Signs this part may need replacing: a cracked or broken housing, corroded or burnt terminals, a locking tab that no longer holds, or an intermittent connection at the coil or module. If a damaged connector is the cause, the S-1533 gives the harness a fresh plug-in point. Diagnose the circuit before replacing any part.
The applications include a wide range of Audi, Volkswagen, SEAT, Bentley, Porsche, Lamborghini, Chevrolet, Buick, GMC, Pontiac and Saturn models. See the "Vehicles it fits" section for the full list and engine details.
Interchange: PT1031 · CONN85786 · EC1030 · 19367598 · 85596545 · 88987987
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does the Standard Ignition S-1533 connector do?
It plugs onto the ignition coil or ignition control module and joins it to the vehicle's wiring harness, carrying the component's electrical signal.
Which vehicles does the S-1533 fit?
It fits many vehicles, including the 1997-2016 Audi A4, 1999-2015 Volkswagen Jetta and 2005-2009 Chevrolet Cobalt. See the "Vehicles it fits" section for the full list.
Does it come with lead wires?
The connector comes factory-assembled. Wire connectors and extended lead wires are supplied where applicable.
How is this connector made and tested?
Standard Ignition builds it to exact OE standards in TS16949- and ISO9001-certified facilities. Each connector gets quality checks and testing at every stage of production.
What are signs the connector may need replacing?
A cracked housing, corroded or burnt terminals, a broken locking tab or an intermittent connection at the coil or module are signs the connector may need replacing. Diagnose the circuit before replacing it.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.