Standard Ignition Ignition Contact Set P/N:GB-4173P
Standard Motor Products
Give a classic breaker-point distributor a fresh set of contacts with the Standard Ignition Contact Set (Points) GB-4073P. It is a direct-fit replacement for the listed applications and fits many vehicles, among them the 1975-1976 Mercedes-Benz 280, the 1975-1978 BMW 530i and the 1977-1978 BMW 630CSi; see the "Vehicles it fits" section for the full list. As the distributor cam turns, the contact set opens and closes the ignition coil's primary circuit to time the spark.
Standard Ignition has served the automotive aftermarket since 1919. As a global maker of original equipment ignition products, it controls quality through every stage of manufacturing, from components to the finished unit.
Signs the points may need replacing: hard starting, misfiring, rough running, or burned and pitted contacts. Other ignition parts can cause the same symptoms, so diagnose the cause first. After installation, check the point gap, dwell and ignition timing against the vehicle service information.
See the "Vehicles it fits" section for engine details.
Interchange: A519 · 1237013037 · 1237013057 · 1237013079 · 1237013086 · 1237013108 · 1237013122 · 1237013139 · RB19 · CS312 · CS312P · 12308982 · 19110473 · 89057190 · 9293046 · 21941009 · 21941029 · 21941034 · CS37 · CS411 · CS413 · CS59 · 592730 · 111998063
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does an ignition contact set do?
The contact set, also called breaker points, opens and closes the ignition coil's primary circuit as the distributor cam turns, which times the spark for each cylinder.
Which vehicles does GB-4073P fit?
It fits many vehicles, among them the 1975-1976 Mercedes-Benz 280, the 1975-1978 BMW 530i and the 1977-1978 BMW 630CSi. See the "Vehicles it fits" section for the full list.
What is the felt pad on this contact set for?
The lubricated felt pad lubricates the distributor's cam lobes. This reduces wear on the points' rubbing block and helps extend the part's usable life.
Do I need to adjust the points after installing them?
The unit comes pre-aligned and pre-adjusted to save installation time. After installation, check the point gap, dwell and ignition timing against the vehicle service information.
What are signs the points may need replacing?
Hard starting, misfiring, rough running, or burned and pitted contacts can be signs. Other ignition parts can cause the same symptoms, so diagnose the cause before replacing.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.