Standard Ignition Ignition Knock (Detonation) Sensor P/N:KS446
Standard Motor Products
Standard Ignition KS101 ignition knock (detonation) sensor for the 1993-1996 Toyota Corolla 4-cylinder 1.8L and other vehicles picks up engine knock vibration and sends a voltage signal in response.
A worn or failing knock sensor can show up as a check engine light, pinging under load or lost power. Before you replace the sensor, rule out a damaged connector or wiring and any real engine knock, since a warning light or lost power can come from several places.
The 1993-1996 Toyota Corolla 4-cylinder 1.8L, the 1992-1995 Toyota 4Runner 4-cylinder 2.4L and the 1994-1999 Toyota Paseo 4-cylinder 1.5L each take one of these knock sensors, and it fits many other Toyota, Lexus and Geo models where the quantity varies by engine. This listing is a single sensor. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One knock sensor. Mounting hardware is not included, so plan on new hardware rather than reusing the old.
Interchange: S8644 · SU4759 · DKS539 · 94854346 · 8961520040 · 8961522040
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Standard Ignition KS101 knock sensor fit a 1992-1995 Toyota 4Runner 4-cylinder 2.4L?
Yes. Standard Ignition KS101 fits the 1992-1995 Toyota 4Runner 4-cylinder 2.4L, which takes one sensor. Use the "Vehicles it fits" section to check other models and engines.
Does the KS101 knock sensor come with mounting hardware?
No. The Standard Ignition KS101 is the sensor only, and mounting hardware is not included, so plan on new hardware.
What knock frequency range does this knock sensor respond to?
It responds to knock frequencies up to 1000 Hz, which accommodates shifts in engine knock frequency across a broad range of vehicle conditions.
What connector does this knock sensor have?
This knock sensor has one female connector with a single male blade terminal. Its attachment method is listed as push-in.
How is the Standard Ignition KS101 knock sensor tested?
Every unit gets an accelerometer-based vibration test. An automated data acquisition system also monitors sensor output for the right voltage at the specified frequency range.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.