Standard Ignition Ignition Switch P/N:US-136
Standard Motor Products
Route key-turn power to the ignition, accessory and starter circuits with the Standard Ignition Starter Switch US-293. It installs as a direct-fit replacement for many vehicles, among them the 1997-2001 Dodge Ram 1500, the 1997-2001 Dodge Ram 2500 and the 1997-1998 Jeep Grand Cherokee. See the "Vehicles it fits" section for the full list and engine details by application.
The ignition starter switch is the electrical switch that the ignition key operates. Each key position sends battery power to a different group of circuits, and the START position energizes the starter circuit.
Signs this switch may need replacing include no crank when the key is turned to START, stalling or loss of power while driving, and dash lights or accessories that cut out in certain key positions. A weak battery, a failed starter, a bad relay or faulty wiring can cause similar symptoms, so diagnose the cause first. If the ignition switch is at fault, the US-293 replaces it.
Interchange: 2-IS146
2IS146 · CS596 · 56021346 · 56021346AB · LS922 · KS6203 · KS6203SB
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does the Standard Ignition US-293 ignition starter switch do?
The ignition key operates this electrical switch. Depending on the key position, it sends power to the ignition, accessory and starter circuits.
Which vehicles does the US-293 fit?
It fits many vehicles, among them the 1997-2001 Dodge Ram 1500, 1997-2001 Dodge Ram 2500 and 1997-1998 Jeep Grand Cherokee. See the "Vehicles it fits" section for the full list.
What signs suggest the ignition switch may be failing?
Common signs are no crank at START, stalling or power loss while driving, and accessories or dash lights cutting out. Diagnose first, because batteries, relays or wiring can cause similar symptoms.
Is the US-293 tested before it ships?
Yes. Standard Ignition 100% tests its switches to verify both mechanical and electrical switching performance.
What are the switch's conductors made of?
The US-293 uses copper alloy conductors, which provide strong electrical conductivity with low resistive losses.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.