Keep the key turning and every start-up circuit switching cleanly with the Standard Ignition Ignition Switch US-657 (also written US657), also known as an Ignition Starter Switch. It drops in as a direct-fit replacement for the 1992-1996 Mitsubishi Diamante — see the Buyer's Guide tab for full engine details. The ignition switch routes battery power to the accessory, run, and start circuits as the key is turned, so a worn or failing switch can leave you with intermittent no-start, dead accessories, or a stalling condition; if the ignition switch is the cause, this replaces it.
Interchange: CS1017 · LS817 · KS7013 · MB697289
This part cross-references / interchanges with the following part numbers:
What vehicle does this ignition switch fit?
It is a direct-fit replacement for the 1992-1996 Mitsubishi Diamante. Check the Buyer's Guide tab to confirm fitment for your vehicle.
What does the ignition switch do?
It routes battery power to the accessory, run, and start circuits as you turn the key, controlling how the electrical system and starter are energized.
What are signs my ignition switch may need replacing?
Intermittent no-start, dead accessories, or stalling can be signs. Diagnose the cause first; if the ignition switch is at fault, this part replaces it.
What numbers does this part interchange with?
It cross-references CS1017, LS817, KS7013, and MB697289.
Is this switch tested before shipping?
Yes. Each unit is 100% tested to verify both its mechanical and electrical switching performance.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
