Standard Ignition Oxygen Sensor Connector P/N:S-1534
$40.99
(You save)
Restore the electrical link to your oxygen sensor with the Standard Ignition Oxygen Sensor Connector S-1534. This connector supplies the plug-in wiring interface between the O2 sensor and the vehicle's engine harness, and it fits a wide range of GM trucks, SUVs, and vans — including the 2006-2007 Buick Rainier, 2003-2006 Cadillac Escalade, 2008-2013 Chevrolet Express 1500, 2003-2006 Chevrolet Silverado 1500, 2009-2011 Chevrolet Traverse, 2003-2006 GMC Sierra 1500, 2003-2006 Hummer H2, and the 2007 Saab 9-7X. See the Buyer's Guide tab for the full list of 57 applications.
Function: Provides the connection point that joins the oxygen sensor to the engine wiring harness so the sensor signal can pass to the control module.
Direct replacement: Installs in place of a damaged, corroded, or melted original connector on the listed applications.
Signs it may need replacing: A corroded, cracked, or heat-damaged connector, or intermittent/lost contact at the O2 sensor plug. Diagnose the circuit before replacing.
Interchange: PT1032 · 1054 · EC1031 · 12092839 · 13585848 · 88987991 Manufacturer part number S-1534.
This part cross-references / interchanges with the following part numbers:
It provides the plug-in electrical connection that joins the oxygen sensor to the vehicle's engine wiring harness so the sensor's signal can reach the control module.
Will this connector fit my vehicle?
It's listed for 57 GM applications, including the 2003-2006 Chevrolet Silverado 1500 and 2003-2006 GMC Sierra 1500. Check the Buyer's Guide tab to confirm your exact year, make, and model.
What are the interchange numbers for S-1534?
It cross-references PT1032, 1054, EC1031, 12092839, 13585848, and 88987991. The manufacturer part number is S-1534.
When should I replace the oxygen sensor connector?
Consider replacement if the connector is corroded, cracked, melted, or making intermittent contact. Diagnose the O2 sensor circuit first to confirm the connector is the cause.
Does this include the oxygen sensor?
This listing is for the oxygen sensor connector only, not the sensor itself. Refer to the vehicle service information for the correct installation procedure.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Oxygen Sensor Connector P/N:S-1534
Reconnect your oxygen sensor to the engine wiring harness with the Standard Ignition Oxygen Sensor Connector S-912. It's a direct-fit replacement for a broad GM lineup, including the 1997-2005 Buick...
Keep the signal flowing between your oxygen sensor and the engine wiring harness with the Standard Ignition Oxygen Sensor Connector S-938. It installs as a direct-fit replacement across a wide range...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
