Standard Ignition PBA014 rear parking brake actuator for the 2018-2024 Chevrolet Malibu and other vehicles applies and releases the parking brake at the rear wheel. It is a direct-fit OE replacement, and its materials meet OE standards.
- 200+ hours of vibration testing in validation
- 1000+ hours of extreme heat and cold operation in validation
Quick facts
- Part: Standard Ignition PBA014 parking brake actuator
- Fits: 2018-2024 Chevrolet Malibu and other vehicles
- Position: Rear, rear right, rear left
- Condition: New
A rear parking brake that will not apply or release, or a parking brake warning on the dash, can mean the actuator is failing. Before you replace it, rule out wiring, the connector and the rest of the rear brake hardware, because a fault there can look like a bad actuator.
Fits
It is listed for a wide range of Buick, Cadillac and Chevrolet models, including the 2018-2024 Chevrolet Malibu, the 2018-2019 Buick LaCrosse and the 2024 Chevrolet Trax. This listing is one actuator; the opposite side of the rear axle takes its own, and both sides are normally done at the same time. If your car is not named here, look it up in the "Vehicles it fits" section on this page.
Specifications
Fit and size
- Position: rear, rear right, rear left
- Electrical connector: 1 female, oval and rectangular shape
- Electrical terminals: 2 male blade
Build and materials
- Condition: New
- Hardware: mounting gasket and mounting bolts
- Country of origin: China
In the box
One parking brake actuator, a mounting gasket and mounting bolts.
Installation notes
- Plug and play, with no additional programming required.
- The direct-fit design is made for ease of installation.
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Is the Standard Ignition PBA014 right for a 2018-2024 Chevrolet Malibu?
Yes. The Standard Ignition PBA014 is listed for the 2018-2024 Chevrolet Malibu and the 2018-2019 Buick LaCrosse; the "Vehicles it fits" section covers other cars.
Do I get mounting bolts and a gasket with this parking brake actuator?
Yes. The Standard Ignition PBA014 comes with one actuator, a mounting gasket and mounting bolts.
What connector does the PBA014 parking brake actuator use?
It has one female electrical connector in an oval and rectangular shape, with two male blade terminals.
Does this parking brake actuator need programming after installation?
No. It is plug and play, and no additional programming is required.
What testing does this parking brake actuator go through?
Validation includes 200+ hours of vibration testing and 1000+ hours of extreme heat and cold operation.
