Standard Ignition Steering Angle Sensor P/N:SWS122
Standard Motor Products
Standard Ignition SWS127 steering angle sensor for the 2021-2025 Ford E-350 Super Duty and other vehicles senses how far the steering wheel is turned.
A stability or traction control warning light, or steering wheel buttons that stop responding, can mean a steering angle sensor or clock spring problem, but other faults produce the same signs. As a first check, note which dash warning lights are on with the engine off and the key on, then have a shop scan the stored codes before you replace anything.
The 2021-2025 Ford E-350 Super Duty, the 2021-2025 Ford E-450 Super Duty and the 2017-2023 Ford F-250 Super Duty all take this steering angle sensor, and so do other vehicles. Driving something else? Look up your own truck or car in the "Vehicles it fits" section. A vehicle needs just one sensor.
One steering angle sensor. Mounting hardware is not included, so plan on new fasteners rather than reusing old ones. Turn signal, lighting, cruise control and wiper controls are not included either.
Interchange: S19027 · SW227 · EJ7Z3F818A · HC3Z3F818A
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the SWS127 steering angle sensor right for the 2021-2025 Ford E-350 Super Duty?
Yes. Standard Ignition SWS127 fits the 2021-2025 Ford E-350 Super Duty and the 2017-2023 Ford F-250 Super Duty. Other trucks and cars are in the "Vehicles it fits" section.
Does the SWS127 steering angle sensor come with mounting hardware?
No. Standard Ignition SWS127 comes as one sensor, without hardware or turn signal, lighting, cruise control or wiper controls.
Are the conductors in this steering angle sensor copper?
Yes. The conductors are a copper alloy, which gives high electrical conductivity with low resistive losses.
Which dash lights can come on when a steering angle sensor starts to fail?
A stability or traction control warning light can come on, and steering wheel buttons may stop responding. A shop can read the stored codes to see what is behind them.
Does Standard Ignition SWS127 replace number HC3Z3F818A?
Yes. HC3Z3F818A is one of the other numbers this sensor replaces, and the Interchange line gives the rest.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.