Standard Ignition Steering Angle Sensor P/N:SWS41
Standard Motor Products
Standard Ignition SWS74 stability control steering angle sensor for the 2014-2019 Toyota Corolla and other vehicles measures how far the steering wheel is turned. The stability control system uses that reading, and each vehicle takes one sensor.
A stability control or traction control warning light can come on when the sensor or its circuit has a fault. Before replacing it, look over the connector with the engine off for damage, corrosion or a loose plug; a scan tool test is a job for a shop. If the sensor is the cause, this one replaces it.
As a stability control steering angle sensor, it also fits the 2015-2017 Toyota Camry and the 2014-2019 Toyota Highlander, along with many other Toyota and Lexus models. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One stability control steering angle sensor. Mounting hardware is not included, so plan on new fasteners rather than reusing the old ones.
Interchange: S8567 · ACSA30 · SWS174 · 8924509045 · 8924B0E020 · 8924B62010
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Standard Ignition SWS74 fit the 2014-2019 Toyota Corolla?
Yes. Standard Ignition SWS74 fits the 2014-2019 Toyota Corolla and the 2015-2017 Toyota Camry. Open the "Vehicles it fits" section to check your exact model and engine.
Does the SWS74 steering angle sensor come with mounting hardware?
No. This listing is one stability control steering angle sensor, and hardware is not included. Plan on new fasteners instead of reusing the old ones.
How many pins does the SWS74 connector have?
The connector is a rectangular female plug-in with 5 male pin terminals. The sensor has one connector.
What can a failing steering angle sensor show on the dash?
A stability control or traction control warning light is a common sign. A shop can read this sensor's data with a scan tool.
Which other part numbers match the Standard Ignition SWS74?
Standard Ignition SWS74 is cross-referenced to S8567, ACSA30, SWS174 and 8924509045, along with the other numbers on the Interchange line.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.