Mevotech TTX Suspension Ball Joint P/N:TXMS90516
Mevotech TTX TXMS50532 front lower ball joint for the 2014-2018 Chevrolet Silverado 1500 and other vehicles forms the pivot between the control arm and the steering knuckle.
A worn ball joint can show up as a clunk over bumps, loose steering or uneven tire wear. Before you replace it, rule out worn control arm bushings, tie rod ends and wheel bearings, which can make similar noises. This listing is one ball joint, and each vehicle takes two, one on each side of the front axle, so order two and fit them together.
The vehicles it fits include the 2014-2018 GMC Sierra 1500, and it is the front lower ball joint for the 2015-2019 Chevy Tahoe. If your truck or SUV isn't named here, look up its year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One ball joint with its dust boot, a 180 degree SAE grease fitting, a part-specific slotted castle nut and a snap cotter pin.
Interchange: 410-18012 · 410-538066
19383223 · 22855747 · 23125970 · TC5664 · TC6928 · BJ92325 · BJ92325XL · FA500245 · FA6541 · GFA500245 · K500245 · 13200 · X07BJ7018 · JBJ1135
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Do these Chevy Silverado 1500 ball joints fit a 2014-2018 truck?
Yes. Mevotech TTX TXMS50532 is a front lower ball joint for the 2014-2018 Chevrolet Silverado 1500, and each truck takes two. For other models, use the "Vehicles it fits" section.
Is this the ball joint for a 2014-2018 GMC Sierra 1500?
Yes. This front lower ball joint fits the 2014-2018 GMC Sierra 1500, and the Sierra takes two, one on each side of the front axle.
Is this Mevotech TTX suspension ball joint greaseable?
Yes. Mevotech TTX TXMS50532 comes pre-greased, and its 180 degree SAE grease fitting is included for later servicing.
Does the TXMS50532 ball joint come with a castle nut and cotter pin?
Yes. The ball joint ships with a part-specific slotted castle nut, a snap cotter pin and a 180 degree SAE grease fitting.
How does this front lower ball joint mount, press-in or bolt-on?
This ball joint is a press-in design with a threaded stud. It presses into the larger flange diameter and is secured with the slotted castle nut and snap cotter pin provided.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.