Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:522-338
$55.99
(You save)
Help keep the rear suspension riding smooth and stable with the Dorman control arm 522-338, a rear right upper replacement for the 2004-2006 Chrysler Sebring and 2004-2006 Dodge Stratus. It installs as a direct replacement for the original assembly on these applications. It arrives with the ball joint and bushings pre-installed, which saves time and labor on the job.
Direct replacement: designed to directly replace the original assembly on the listed vehicle applications.
Pre-installed components: the ball joint and bushings come already installed, cutting installation time and labor.
Tested engineering: put through an industry-leading evaluation process, intended to deliver a smooth ride, directional stability and predictable dynamics.
Rust protection: additional coatings help resist rust and corrosion.
This Dorman suspension control arm and ball joint assembly links the rear wheel assembly to the vehicle's chassis at the right upper position. It lets the wheel move with the suspension while helping keep it properly located. Signs it may need replacing include clunking or knocking over bumps, uneven tire wear, loose or wandering handling, and a torn ball-joint boot or worn bushings. Diagnose the cause before replacing. The arm is sold individually. Replacing the matching left-side arm at the same time is recommended, and a wheel alignment is advised after installation. Consult the vehicle service information for the correct fasteners and whether they may be reused. See the Buyer's Guide tab for full fitment details.
It is a direct replacement for the rear right upper position on the 2004-2006 Chrysler Sebring and 2004-2006 Dodge Stratus. See the Buyer's Guide tab for full fitment details.
What comes with this control arm?
The assembly arrives with the ball joint and bushings pre-installed, saving time and labor. Consult the vehicle service information for the correct fasteners and whether the originals may be reused.
What position does this arm install in?
It is cataloged for the rear right upper position. It is sold individually, and replacing the left-side arm at the same time is recommended.
What are signs this control arm may need replacing?
Signs include clunking over bumps, uneven tire wear, wandering or loose handling, and a torn ball-joint boot or worn bushings. Other parts can cause similar symptoms, so diagnose the cause before replacing.
Is the arm protected against rust?
Yes. Dorman applies additional coatings intended to help the arm resist rust and corrosion.
Write a Review
Dorman - OE Solutions
Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:522-338
Suspension Control Arm And Ball Joint AssemblyThis suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An...
Help keep your front suspension steady and predictable with this Dorman control arm, part number 522-812, a front right lower control arm with ball joint for the 2012-2018 Ford Focus, 2019-2023 Ford...
Tackle a worn front right upper arm in one job with the Dorman upper control arm, part number 522-468, a direct replacement for the original equipment on the 2009-2010 Dodge Ram 1500, 2011-2018 Ram...
This suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An industry-leading evaluation process ensures a smooth ride,...
Tackle a worn front suspension link in one step with the Dorman control arm 522-236, a Control Arm with Ball Joint for the front right lower position on the 2005-2009 Subaru Outback and the 2005-2009...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
