Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS501030
Mevotech Supreme CMS101147 front left lower control arm with ball joint for the 2006-2014 Volkswagen Jetta and other vehicles connects the front left wheel to the chassis. This Mevotech Supreme suspension control arm includes the ball joint, bushings and dust boot, and its stamped steel construction meets or exceeds OE specifications.
A clunk over bumps, loose or wandering steering, or uneven front tire wear can mean a worn arm or ball joint, though worn parts elsewhere in the suspension produce similar symptoms. Before replacing it, look it over with the engine off for cracked bushing rubber, a torn dust boot or grease leaking from the joint, and leave play testing to a shop.
The 2006-2014 Volkswagen Jetta, 2010-2014 Volkswagen Golf and 2010-2016 Volkswagen Eos each take one of these on the front left, and it fits more models besides. Driving something else? Look up your own car in the "Vehicles it fits" section. This listing is one arm; the front right is a separate part, and both sides are normally replaced together.
Fit and size
Build and materials
One control arm with ball joint, rubber bushings, rubber dust boot and mounting hardware.
Product information is for general reference and may contain errors. See our Disclaimer.
Does this control arm fit a 2006-2014 VW Jetta?
Yes. Mevotech Supreme CMS101147 is a front left lower control arm for the 2006-2014 Volkswagen Jetta. If your car is a different one, look for it in the "Vehicles it fits" section.
Is this Golf control arm the right one for a 2010-2014 Volkswagen Golf?
Yes. The 2010-2014 Volkswagen Golf takes one of these on the front left. This listing is the left side only, and the right side is ordered separately.
What comes with this control arm and ball joint assembly?
Mevotech Supreme CMS101147 includes the ball joint, rubber bushings, rubber dust boot and mounting hardware, plus a part-specific nylon locking nut for the ball joint.
Does this Mevotech Supreme lower control arm have a bolt-in ball joint?
Yes. The ball joint is a bolt-in type with a threaded stud, and it comes pre-greased.
Is this control arm made of steel, and is it rust-protected?
Yes. The arm is stamped steel with a protective surface treatment that resists rust, and the bushings and dust boot are rubber.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.