Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS301253
Mevotech Supreme CMS101276 front left lower control arm with ball joint for the 2013-2019 BMW 640i Gran Coupe and other vehicles joins the wheel to the chassis. This Mevotech Supreme suspension control arm and ball joint assembly comes pre-greased.
A worn lower control arm can show up as a clunk over bumps, uneven front tire wear or vague steering. These signs alone do not prove this arm is the problem, since a worn tie rod end can cause similar play. This listing is one arm for the front left lower forward position; each side of the front axle takes its own, and both sides are normally replaced together.
The 2013-2019 BMW 640i Gran Coupe, the 2013-2019 BMW 650i Gran Coupe and the 2012-2018 BMW 640i are among the BMW models this control arm fits.
Fit and size
Build and materials
One control arm with ball joint and rubber bushings.
Interchange: 102-7746 · 522-885
19327265 · 31126775971 · MGS101276 · TC2821 · CB14413 · CB14413PR · CA4979 · 4CB101327 · RK641509 · C6GS101276 · GS101276 · 2606858 · 1672101 · 30036240 · X05CJ1115 · JTC2206
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will the Mevotech Supreme CMS101276 control arm fit a 2013-2019 BMW 650i Gran Coupe?
Yes, Mevotech Supreme CMS101276 fits the 2013-2019 BMW 650i Gran Coupe, and the 2013-2019 BMW 640i Gran Coupe too. For a different BMW, find your car in the "Vehicles it fits" section.
Does this Mevotech Supreme lower control arm come with the ball joint and bushings?
Yes. Mevotech Supreme CMS101276 is a control arm with the ball joint and rubber bushings included, so no separate joint is needed.
How big is the Mevotech Supreme CMS101276 control arm?
Maximum width is 14.0 in and maximum length is 17.13 in, handy for comparing against your old arm. The arm itself is aluminum.
How do I spot a worn bushing or ball joint on a front lower control arm?
A clunk over bumps, loose steering or a pull to one side can come from worn bushings or a worn ball joint, among other causes. A shop can inspect the bushings during a brake or tire service and test the joint.
Does the ball joint come pre-greased, and what nut does it use?
Yes, it is pre-greased. A part-specific nylon locking nut is provided for the threaded stud, and the joint is a press-in type.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.