Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS90110
Mevotech Supreme CMS20403 front right lower control arm with ball joint for the 1998-2011 Ford Ranger and other vehicles locates the right front wheel as the suspension moves. This Mevotech Supreme suspension control arm is also called a control arm and ball joint assembly and comes with its bushing.
A worn arm or ball joint can show up as a clunk over bumps, loose steering or uneven front tire wear. Before you replace it, rule out worn tie rod ends, sway bar links or shocks, which can cause similar signs. Both sides are usually replaced together, though this listing is one arm for the front right; the left is a separate part. The front axle takes one arm on each side.
This lower control arm with ball joint fits the 1998-2011 Ford Ranger, and it works as a lower control arm for the 1995-2001 Ford Explorer and the 1998-2010 Mazda B4000. If your vehicle is not one of these, open the "Vehicles it fits" section and look up your exact model and engine.
Fit and size
Build and materials
One front right lower control arm with ball joint and its bushing, a 90 degree SAE grease fitting, and a part-specific castle nut and cotter pin.
Product information is for general reference and may contain errors. See our Disclaimer.
Is CMS20403 a control arm for the 1998-2011 Ford Ranger?
Yes. Mevotech Supreme CMS20403 fits the 1998-2011 Ford Ranger at the front right lower position. Other vehicles are covered too, so open the "Vehicles it fits" section to look up yours.
Does this work as a control arm for the 1995-2001 Ford Explorer?
Yes. Mevotech Supreme CMS20403 fits the 1995-2001 Ford Explorer on the front right lower side. The left side is a separate part.
Is the Mevotech Supreme control arm greaseable?
Yes. This arm is pre-greased and includes a 90 degree SAE grease fitting, so the ball joint can be serviced later.
Do the castle nut and cotter pin come with this arm?
Yes. The part-specific castle nut and cotter pin are included, along with the bushing and a 90 degree SAE grease fitting. The ball joint stud is threaded.
What is this lower control arm made of?
The control arm is steel, with a rubber bushing and a sintered metal bearing. It also has a protective surface treatment to resist rust.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.