Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS251124
Mevotech Supreme CMS25112 front left upper control arm with ball joint for the 2000-2004 Dodge Dakota and other vehicles links the steering knuckle to the chassis. This Mevotech Supreme suspension control arm, also called a control arm and ball joint assembly, is built for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks.
A worn upper control arm or ball joint can show up as a clunk over bumps, loose or wandering steering, or uneven tire wear. Before you replace this arm, rule out other worn front-end parts such as tie rod ends or wheel bearings, which can give similar clunks and looseness. Both front upper arms are normally replaced together; this listing is one arm for the front left, and the front right is ordered separately.
It is a direct-fit upper control arm for the 2000-2004 Dodge Dakota and the 2000-2003 Dodge Durango. The 2000-2004 Dodge Dakota takes one arm in this front-left position.
Fit and size
Build and materials
One control arm with ball joint, with its bushings, mounting hardware, castle nut, cotter pin and grease fitting.
Product information is for general reference and may contain errors. See our Disclaimer.
Is this a Dodge Dakota control arm for the 2000-2004 truck?
Yes. Mevotech Supreme CMS25112 fits the 2000-2004 Dodge Dakota in the front left upper position.
Can I use this Dodge Durango control arm on a 2000-2003 Durango?
Yes. Mevotech Supreme CMS25112 fits the 2000-2003 Dodge Durango on the front left upper side; the right side is a separate part.
Does the Mevotech Supreme control arm come with a castle nut and cotter pin?
Yes. The assembly includes a part-specific castle nut and cotter pin, plus bushings, mounting hardware and a 180 degree SAE grease fitting.
What are the bearing and bushing materials in this front left upper control arm?
The bearing is sintered metal and the bushings are rubber. The control arm itself is steel.
Does this control arm need greasing before it goes on?
No. The ball joint comes pre-greased, and it is greaseable later through the included 180 degree SAE grease fitting.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.