Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS20380
Mevotech Supreme CMS251163 front right lower control arm with ball joint for the 2013-2023 Dodge Charger and other vehicles links the wheel to the chassis. Also sold as a control arm and ball joint assembly, it includes the ball joint, rubber bushings and a rubber dust boot on a steel arm.
A worn arm or ball joint can show up as a clunk over bumps, uneven tire wear or loose steering. Before you replace this arm, rule out worn tie rod ends, sway bar links and a worn strut, which can give similar noises. The front axle takes one arm per side; this listing is the front right, the front left is ordered separately, and both sides are normally replaced together.
It fits the front right lower position on the 2013-2023 Dodge Charger and the 2012-2023 Chrysler 300, and it is also a control arm for the 2017-2023 Dodge Challenger.
Fit and size
Build and materials
One front right lower control arm with ball joint, rubber bushings, a rubber dust boot and mounting hardware.
Interchange: 622.63049 · 524-054
19383200 · 05168282AB · 5168282AA · 5168282AB · TC6013 · 68211102AA · 68211102AB · CA12605 · 2608477 · 30034249 · 9CB25339 · X13CJ0720
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the front right control arm for the 2013-2023 Dodge Charger?
Yes. Mevotech Supreme CMS251163 is the front right lower arm for the 2013-2023 Dodge Charger. The left side needs its own arm.
Is this the right control arm for the 2012-2023 Chrysler 300?
Yes. Mevotech Supreme CMS251163 fits the front right lower position on the 2012-2023 Chrysler 300.
What comes with this Mevotech Supreme control arm?
This control arm comes with the ball joint, rubber bushings, a rubber dust boot, mounting hardware, a 135 degree SAE grease fitting and a part-specific nylon locking nut.
Is this control arm greaseable?
Yes. This control arm is greaseable and pre-greased, and a 135 degree SAE grease fitting is included for servicing.
What are the bushing and bearing materials in this control arm?
The bushings and dust boot are rubber, the bearing is sintered metal and the control arm itself is steel.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.