Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS101482
Mevotech Supreme CMS25117 front left upper control arm with ball joint for the 2006-2023 Dodge Charger and other vehicles ties the wheel to the chassis and pivots at the ball joint. This control arm and ball joint assembly is engineered in-house with application-specific upgrades.
A clunk over bumps, uneven tire wear or loose steering can mean a worn control arm or ball joint, though worn parts elsewhere in the suspension can feel much the same. Before you replace anything, look the arm over with the engine off and the car cool for cracked bushing rubber, a bent arm or grease seeping from the joint.
The 2006-2023 Dodge Charger, 2005-2023 Chrysler 300 and 2008-2023 Dodge Challenger take this control arm as a direct-fit replacement, and so do other vehicles. This listing is one arm for the front left upper position; the front right upper is a separate part, and both sides are normally replaced together. Driving something else? Look up your year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One control arm with ball joint, with bushings, mounting hardware, a grease fitting and the part-specific locking nut.
Product information is for general reference and may contain errors. See our Disclaimer.
Is CMS25117 the front left upper control arm for the 2006-2023 Dodge Charger?
Yes. Mevotech Supreme CMS25117 is the front left upper control arm with ball joint for the 2006-2023 Dodge Charger. The front right upper side is a separate part.
Does this control arm fit the 2005-2023 Chrysler 300?
Yes. Mevotech Supreme CMS25117 fits the 2005-2023 Chrysler 300 in the front left upper position; the front right upper side takes its own arm.
Is the ball joint on CMS25117 press in or bolted?
The ball joint mounting type is press in, with a threaded stud. A part-specific locking nut is provided for the ball joint.
Does the Mevotech Supreme CMS25117 control arm come with a grease fitting and hardware?
Yes. This control arm comes with bushings, mounting hardware, a 180 degree SAE grease fitting and a part-specific locking nut for the ball joint.
What is this control arm made of, and how is it protected from rust?
The control arm is steel with rubber bushings and a sintered metal bearing. A protective surface treatment helps resist rust build-up.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.