Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS25170
Mevotech Supreme CMS25194 front left lower control arm with ball joint for the 2011-2012 Ram 1500 and other vehicles joins the wheel assembly to the frame and lets it pivot with the suspension. The assembly includes rubber bushings, and its stamped steel construction is built to meet or exceed OE specifications.
A clunk over bumps, loose steering or uneven front tire wear can point to a worn ball joint or worn bushings. Before you replace this arm, rule out the tie rod ends, sway bar links and wheel bearing, since wear in those parts can give a similar clunk or tire wear.
This Mevotech Supreme control arm fits the 2011-2012 Ram 1500 and the 2006-2010 Dodge Ram 1500. This listing is one arm for the front left, so that side takes one; the front right is a separate part ordered on its own, and the two sides are normally replaced together.
Fit and size
Build and materials
One control arm with ball joint and bushings, plus a castle nut, a cotter pin and a 90 degree SAE grease fitting.
Product information is for general reference and may contain errors. See our Disclaimer.
Is this the Ram 1500 lower control arm for the left or right side of the 2011-2012 model?
Mevotech Supreme CMS25194 is the front left lower control arm for the 2011-2012 Ram 1500. The front right is a separate part.
Is this lower control arm for the 2012 Ram 1500 the same one the 2006-2010 Dodge Ram 1500 takes?
Yes. Mevotech Supreme CMS25194 is listed for both the 2011-2012 Ram 1500 and the 2006-2010 Dodge Ram 1500, in the front left lower position.
Does this control arm and ball joint assembly include a castle nut and grease fitting?
Yes. It comes with a part-specific castle nut, a cotter pin and a 90 degree SAE grease fitting, along with the bushings.
Does the Mevotech Supreme CMS25194 come pre-greased?
Yes. This Mevotech Supreme CMS25194 is pre-greased and greaseable, and a 90 degree SAE grease fitting is included. It uses sintered bearings, and the arm is stamped steel.
How is the ball joint stud secured on this arm?
The ball joint is secured to the vehicle with the part-specific castle nut and cotter pin provided. The stud is threaded.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.