Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS50102
$132.99
(You save)
Keep the front wheel located and steering geometry in check with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMS50102). This front left upper control arm and ball joint assembly installs as a direct-fit S10 control arm for the 1982-2003 Chevrolet S10 and 1991-2003 GMC Sonoma, and also covers the 1995-2005 Chevrolet Blazer, 1985-1994 Chevrolet S10 Blazer, 1992-2001 GMC Jimmy, 1982-1987 Buick Regal, 1978-1987 Pontiac Grand Prix and more — see the Buyer's Guide tab for the full list.
Engineered in-house by Mevotech Supreme for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks, this Mevotech Supreme control arm carries a ball joint and connects the frame to the steering knuckle so the wheel can move through its travel while holding alignment.
Stamped steel construction: built to OE-level tolerances.
Sintered bearings: for longer-lasting performance.
Serviceable design: includes a 180-degree SAE grease fitting.
Ready to install: a thicker, stronger ball joint flange helps prevent deformation during installation, and a part-specific castle nut and cotter pin are provided.
Sold individually for the front left upper position.
Frequently Asked Questions
Will this fit my Chevy S10?
Yes — this chevy S10 control arm is cataloged for the 1982-2003 Chevrolet S10, along with vehicles like the GMC Sonoma and Chevrolet Blazer. Check the Buyer's Guide tab to confirm your exact year and model.
Where does this control arm mount on the vehicle?
It is the front left upper control arm, connecting the frame to the steering knuckle on that corner of the suspension.
Are a grease fitting and mounting hardware included?
Yes. It includes a 180-degree SAE grease fitting for servicing, plus a part-specific castle nut and cotter pin to secure the ball joint to the vehicle.
What is this Mevotech Supreme control arm made of?
It uses stamped steel construction built to OE-level tolerances, finished with a protective surface treatment that helps resist rust build-up.
What are signs the control arm or ball joint may need replacing?
Clunking over bumps, steering wander, or uneven tire wear can be signs. Have the cause diagnosed first, since these symptoms can come from other suspension parts.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS50102
Keep your front suspension tight and controlled with the Mevotech Supreme control arm and ball joint assembly (CMS501027). This front left (driver's side) lower unit drops in as a direct-fit...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
