Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMK9063
Mevotech Supreme CMS501058 front right lower control arm with ball joint for the 2008-2009 Chevrolet Trailblazer and other vehicles locates the front right wheel and lets it pivot and steer. This control arm and ball joint assembly is built for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks.
A clunk over bumps, uneven tire wear or loose steering can mean a worn bushing or ball joint. Before you replace this arm, rule out a worn tie rod end or strut and an alignment problem, which can produce similar symptoms. The front arms are normally replaced as a pair; this listing is one arm, for the front right, and the front left is a separate part.
It fits as a lower control arm for the 2008-2009 Chevrolet Trailblazer, the 2008-2009 GMC Envoy and the 2008-2009 Saab 9-7X, and the front right position on each takes one.
Fit and size
Build and materials
One control arm with ball joint, bushings and mounting hardware, plus the part-specific locking nut.
Interchange: 623.38005 · 521-972
19296444 · SGS501058 · TC6331 · CB91264 · CB91264PR · CA16196 · 25784240 · RK621315 · GS501058 · 2606355 · 2606355M · 1850105 · 30034542 · 12CB50189 · 5071827 · X07CJ1412 · TK621315
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the right control arm for the front right lower side of a 2008-2009 Chevrolet Trailblazer?
Yes. Mevotech Supreme CMS501058 is the front right lower arm and fits the 2008-2009 Chevrolet Trailblazer; the left side is a separate part.
Is this the front right control arm for the 2008-2009 GMC Envoy?
Yes. CMS501058 fits the 2008-2009 GMC Envoy at the front right lower position.
Is this Mevotech Supreme control arm greaseable?
Yes. It comes pre-greased and includes a 90 degree SAE grease fitting for servicing.
Do the bushings and a locking nut come with the control arm?
Yes. The listing includes the bushings, mounting hardware and a part-specific locking nut along with the arm and ball joint.
What type of ball joint and bearing does this arm have?
The ball joint is a press-in type with a threaded stud, and the bearing is sintered metal. The arm is steel with rubber bushings.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.