Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS90110
Mevotech Supreme CMS501255 front left lower control arm with ball joint for the 2016-2019 Chevrolet Cruze and other vehicles connects the wheel to the vehicle and lets the suspension move. This control arm and ball joint assembly includes rubber bushings and a pre-greased ball joint.
A worn lower control arm or ball joint can show up as a clunk over bumps, uneven tire wear or wandering steering. These signs alone do not prove this arm is the problem, since a worn tie rod end can cause similar symptoms.
It is a control arm for the 2016-2019 Chevy Cruze and the 2016-2019 Chevrolet Volt. The car takes one on each side of the front axle; this listing is the front left, and the front right is a separate part that is normally replaced at the same time.
Fit and size
Build and materials
One control arm with ball joint, rubber bushings and mounting hardware.
Interchange: 527-373
19427226 · 13466362 · 39001025 · 39089342 · 84035534 · 84289692 · TC6805 · CB91543 · 23269163 · 23403025 · RK623586 · 2608691 · 30034809 · 5CB50684 · X07CJ0942
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a 2017 Chevy Cruze lower control arm?
Yes. Mevotech Supreme CMS501255 is the front left lower control arm with ball joint for the 2016-2019 Chevrolet Cruze, which includes the 2017 model year.
Is this 2016-2019 Chevy Cruze control arm replacement also made for the 2016-2019 Chevrolet Volt?
Yes. Mevotech Supreme CMS501255 fits the 2016-2019 Chevrolet Volt as well as the 2016-2019 Chevrolet Cruze, in the front left lower position.
What is the Mevotech Supreme control arm made of?
The control arm is stamped steel with a reinforced ball joint head, and the bushings are rubber. A protective surface treatment resists rust build-up.
Does this control arm come with a castle nut and cotter pin?
Yes. Mevotech Supreme CMS501255 includes the part-specific castle nut and snap cotter pin for the ball joint, plus a 90 degree SAE grease fitting.
Is the ball joint on this lower control arm pre-greased?
Yes. The ball joint on this front left lower arm comes pre-greased, and the 90 degree SAE grease fitting allows later servicing.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.