Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS101482
Mevotech Supreme CMS601231 rear left upper control arm with ball joint for the 2016-2023 Honda Pilot and other vehicles locates the rear wheel and lets it move with the suspension. This Mevotech Supreme suspension control arm includes the ball joint, rubber bushings and dust boot.
A worn rear upper arm can show up as a clunk over bumps, uneven tire wear or loose, wandering handling. Before you replace the arm, rule out worn tires, a loose wheel bearing or a weak shock, since those can produce similar signs.
This part is listed for a wide range of Honda and Acura models, including the 2019-2025 Honda Passport and the 2017-2025 Honda Ridgeline, and it is a direct-fit replacement rear control arm for the 2016-2023 Honda Pilot. Open the "Vehicles it fits" section to check your exact model and engine. The rear axle takes one upper arm per side; this listing is the left one, and the right side is a separate part that is normally replaced at the same time. The stamped steel construction is built to meet or exceed OE specifications.
Fit and size
Build and materials
One control arm with ball joint, rubber bushings, neoprene dust boot, grease fitting and mounting hardware.
Interchange: 19390869 · CB50607 · 52520T6ZA00 · 52520T6ZA01 · 52520T6ZA02 · 52520T6ZA03 · 52520TZ5A00 · 52520TZ5A10 · RK623635 · 30031484
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a 2016-2023 Honda Pilot control arm for the rear left upper position?
Yes. Mevotech Supreme CMS601231 is the rear left upper control arm with ball joint for the 2016-2023 Honda Pilot. The right side is a separate part.
Does this 2017-2025 Honda Ridgeline control arm go on the rear left upper side?
Yes, the 2017-2025 Honda Ridgeline is listed for this part, which mounts at the rear left upper position. For any other model, open the "Vehicles it fits" section and check your exact model and engine.
Does this control arm and ball joint assembly come with a grease fitting?
Yes. Mevotech Supreme CMS601231 includes a 90 degree SAE grease fitting, and the ball joint is pre-greased. Mounting hardware is included too.
What are the bearing and boot on this rear upper control arm made of?
This arm has a sintered metal bearing and a neoprene dust boot. The bushings are rubber and the arm itself is steel.
What holds the ball joint on this rear upper arm?
A part-specific slotted castle nut and a snap cotter pin come with the arm and hold the ball joint to the vehicle.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.