Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS501120
Mevotech Supreme CMS801224 front left lower control arm with ball joint for the 2017-2020 Hyundai Elantra and other vehicles connects the front left wheel to the chassis. This Mevotech Supreme suspension control arm is a control arm and ball joint assembly built for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks.
A clunk over bumps, wandering steering or uneven tire wear can come from worn control arm bushings or a worn ball joint. Struts, tie rod ends and wheel bearings can be behind those signs too, so find the cause before you buy.
It is a lower control arm for the 2017-2020 Hyundai Elantra and is listed for a wide range of Hyundai and Kia models, led by the 2019-2024 Kia Forte and the 2020-2024 Kia FORTE5. If your car is not named here, look it up in the "Vehicles it fits" section by year and model. This listing is one arm for the front left of the axle; the front right is a separate part, and the two are normally replaced together.
Fit and size
Build and materials
One front left control arm with ball joint, bushings and dust boot, a 90 degree SAE grease fitting, a part-specific hex nut and mounting hardware. This listing holds one arm, and the front left takes one.
Interchange: 527-479
19472698 · TC2737 · CB600023 · CB60413 · CB60413PR · CA12942 · 54500F2000 · 54500F2AA0 · 54500F3000 · 54500J9000 · 5CB80355 · 2608880 · X18CJ7131
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does this Hyundai Elantra control arm fit the 2017-2020 model years?
Yes. Mevotech Supreme CMS801224 is the front left lower control arm with ball joint for the 2017-2020 Hyundai Elantra.
Does the Mevotech Supreme lower control arm come with a grease fitting?
Yes. Mevotech Supreme CMS801224 includes a 90 degree SAE grease fitting, and its ball joint is pre-greased and greaseable.
Is the ball joint already on this control arm, or sold separately?
The ball joint is pre-assembled on the arm. The bushings and dust boot are included as well.
What is the CMS801224 control arm made of?
The control arm is stamped steel with a protective surface treatment. The bushings are rubber, the bearing is sintered metal and the dust boot is neoprene.
What kind of ball joint stud does this control arm have?
Mevotech Supreme CMS801224 has a threaded ball joint stud with a bolt-in mounting type. The ball stud system is application-specific with a larger sphere.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.