Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMK8501
Mevotech Supreme CMS9704 front right upper control arm with ball joint for the 1977-1985 Chevrolet Impala and other vehicles locates the wheel and holds the ball joint. This Mevotech Supreme suspension control arm, also called a control arm and ball joint assembly, comes with its ball joint and rubber bushings.
A clunk over bumps, uneven front tire wear or loose-feeling steering can point to a worn ball joint or bushing. Before you replace the arm, rule out loose fasteners and other worn suspension parts, since a tired tie rod end or shock can clunk or wander too.
Among the vehicles it fits are the 1992-1996 Cadillac Commercial Chassis and the 1993-1996 Cadillac Fleetwood, along with many others. If your car is not named here, look up its year and model in the "Vehicles it fits" section. This listing is one arm for the front right upper position; each side of the axle takes one, and the left upper arm is a separate part normally replaced at the same time.
Fit and size
Build and materials
One front right upper control arm with ball joint, bushings, mounting hardware and a grease fitting.
Product information is for general reference and may contain errors. See our Disclaimer.
Is this Chevy Impala control arm correct for the 1977-1985 Chevrolet Impala?
Yes. Mevotech Supreme CMS9704 fits the 1977-1985 Chevrolet Impala in the front right upper position. For another car, find its year and model in the "Vehicles it fits" section.
Is the CMS9704 a Cadillac Fleetwood control arm for the 1993-1996 model years?
Yes. CMS9704 fits the 1993-1996 Cadillac Fleetwood in the front right upper position. The left upper arm on that axle is a separate part.
Does this control arm come with a nut and cotter pin for the ball joint?
Yes. Mevotech Supreme CMS9704 includes a part-specific castle nut and cotter pin to secure the ball joint, plus the rubber bushings and a grease fitting.
Is the ball joint on this front right upper control arm greaseable?
Yes. The ball joint is pre-greased and greaseable, and a grease fitting is included. Its stud is threaded and it mounts with a bolt-in type.
What is this control arm made of?
The control arm is steel with rubber bushings. It has a protective surface treatment to resist rust build-up.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.