Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:521-086
Dorman 521-026 front right lower control arm with ball joint for the 2006-2011 Chevrolet HHR and other vehicles holds the front right wheel to the suspension and lets it move with the road. This Dorman suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications.
A clunk over bumps, loose or wandering steering, or uneven front tire wear can mean a control arm or its ball joint is worn. Before you replace this arm, rule out a worn tie rod end, strut or wheel bearing, since those can feel much alike. The front axle has one arm on each side, so this listing covers the right side only; the front left is a separate part, ordered separately, and the two are normally replaced together.
This front right lower control arm also fits the 2005-2010 Chevrolet Cobalt and the 2007-2010 Pontiac G5. For a car not named here, find your make, model and year in the "Vehicles it fits" section.
Fit and size
Build and materials
One control arm with ball joint, with the ball joint and rubber bushings installed, plus mounting hardware. A grease fitting is not included.
Interchange: 810-232985B · 623.62043
TC5190 · CA16289 · 15787555 · 15803767 · 22700094 · 22708764 · 25895744 · 25930724 · RK620897 · GS50174 · CMS50174 · 2606214 · 2606214M · 5CB50119 · SRK620897 · 1503016 · X07CJ0511 · JTC2405
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the right control arm for a 2006-2011 Chevrolet HHR?
Yes. Dorman 521-026 is the front right lower control arm with ball joint for the 2006-2011 Chevrolet HHR. The front left side is a separate part.
Are the Dorman control arm bushings already installed on 521-026?
Yes. The rubber bushings and the ball joint come pre-installed on Dorman 521-026, and the assembly is pre-greased. Mounting hardware is included; a grease fitting is not.
What is this Dorman control arm made of?
The arm is aluminum, casting/forged type, with rubber bushings. The ball joint has a pinch-type stud and a 14 mm thread diameter.
How do I tell if my front right control arm or ball joint is worn?
Noise over bumps, steering that feels loose and tires wearing unevenly in front are what drivers usually notice; any of them can mean a worn arm or ball joint. A shop can measure play in the joint.
Does this front right control arm have a rust-resistant coating?
Yes. Additional coatings give this arm rust and corrosion resistance.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.