Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:527-161
Replace a worn rear lateral link in one step with the Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly 521-527, a ready-to-install unit cataloged for the rear left lower position. It fits many vehicles, among them the 2001-2005 Dodge Stratus, 1995-2000 Dodge Avenger and 2001-2006 Chrysler Cirrus, and it directly replaces the original assembly on the listed applications.
This part is listed as both a Suspension Control Arm and Ball Joint Assembly and a Lateral Link and Ball Joint Assembly. It is cataloged for the rear left lower (rearward) position, where the arm helps locate the rear wheel and control its movement.
Signs this assembly may need replacing include clunking or knocking from the rear over bumps, a loose or wandering feel, uneven tire wear, or visible play at the ball joint or bushings. Diagnose the cause before replacing parts. After installation, have the wheel alignment checked, and consult the vehicle service information for the correct fasteners and whether they may be reused. See the "Vehicles it fits" section for engine details and the full vehicle list.
Interchange: 102-7093
TC5946 · CA2093 · 2CB80228 · RK620995 · RK622783 · GS801144 · CMS801144 · MR124293 · MR162571 · MR162573 · 2606662 · 1027093
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What position does the Dorman 521-527 fit?
It is cataloged for the rear left lower position, listed as rear left lower rearward, on its applications.
Does the Dorman 521-527 fit a 2001-2005 Dodge Stratus?
Yes, the 2001-2005 Dodge Stratus is a listed application, as are the 1995-2000 Dodge Avenger and 2001-2006 Chrysler Cirrus. The "Vehicles it fits" section shows engine details and the full list.
What comes pre-installed on this assembly?
The ball joint and bushings come pre-installed in the arm, so they do not need to be pressed in separately. This saves time and labor.
What are signs this control arm may need replacing?
Clunking or knocking from the rear over bumps, a loose or wandering feel, uneven tire wear, or play at the ball joint or bushings may be signs of wear. Inspect and diagnose the cause before replacing.
Is an alignment needed after installation?
Replacing a suspension arm can affect wheel alignment, so an alignment check afterward is recommended. Consult the service information for fastener torque and whether the original fasteners may be reused.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.