Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:521-086
Dorman 521-725 front left lower control arm with ball joint for the 2008-2013 Nissan Rogue and other vehicles links the front left wheel to the chassis. This Dorman suspension control arm and ball joint assembly is a one-piece repair for a worn arm or ball joint.
A worn arm or ball joint can show as a clunk over bumps, wandering steering or uneven tire wear. Those signs alone do not prove this part is the problem; a tired tie rod end can feel much the same. Lower arms are normally replaced in pairs, one per side of the axle; this listing is the front left only, and the front right is a separate part.
This arm is a direct replacement for the original equipment on specific vehicles. The vehicles it fits include the 2008-2013 Nissan Rogue, the 2009-2016 Renault Koleos and the 2014-2015 Nissan Rogue Select.
Fit and size
Build and materials
One control arm with mounting hardware. A grease fitting is not included.
Interchange: 102-7045 · 810-288748B
TC2467 · CA12376 · 5CB30223 · RK621452 · GS30194 · CMS30194 · 2606670 · 2606670M · 54501JD000 · 54501JG000 · 54501JG00A · 54501JG00B · 545055212R · SK521725 · 1516023 · X36CJ3073 · JTC2677
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the 2008-2013 Nissan Rogue control arm for the front left side?
Yes. Dorman 521-725 is the front left lower control arm with ball joint for the 2008-2013 Nissan Rogue. The front right side is a separate part.
Can I use this 2008-2013 Nissan Rogue lower control arm on a 2009-2016 Renault Koleos?
Yes. Dorman 521-725 also fits the 2009-2016 Renault Koleos. For any other vehicle, look up your car's year in the "Vehicles it fits" section on this page.
Does the Dorman control arm come with the ball joint and bushings?
Yes. Dorman 521-725 has the ball joint and bushings pre-installed, and the ball joint is pre-greased. Mounting hardware is included; a grease fitting is not.
What thread size does the ball joint stud on Dorman 521-725 have?
The ball joint thread diameter is 14 mm, and the stud is a pinch type. The mounting hole in the arm measures 12.2 mm.
How can I tell if a front lower control arm bushing or ball joint is worn?
A shop looks for free play in the ball joint and cracked or torn bushing rubber, which needs the vehicle lifted. A knock from the front end on rough road is a reason to have it checked.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.