Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:526-644
Dorman 526-633 front left lower control arm with ball joint for the 2002-2003 Chevrolet Trailblazer and other vehicles links the front left wheel to the frame. If worn bushings or a loose ball joint cause a clunk over bumps, this control arm and ball joint assembly replaces both.
Uneven tire wear or loose steering can be other signs of a worn arm. Before you replace it, rule out a worn tie rod end, sway bar link or strut mount, since each can cause similar noises or handling changes. Both front lower arms normally get replaced together; this listing is one arm for the front left, and the front right is ordered separately.
This front left lower control arm is a direct replacement for the original equipment on the 2002-2003 Chevrolet Trailblazer, the 2002-2003 Chevrolet Trailblazer EXT, the 2002-2003 GMC Envoy and other vehicles. The 2002-2003 Chevrolet Trailblazer takes one on the front left. To see whether your own car is covered, look up its year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One control arm, one ball joint and one nut, with mounting hardware included. A grease fitting is not included.
Interchange: TC6282 · CA16315 · 15072943 · 15091389 · 15105775 · 15165150 · 15167262 · 15183144 · 15198486 · 19133553 · 89060576 · RK620310 · GS50154 · CMS50154 · 2606019 · 12CB50094 · JTC2402
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is Dorman 526-633 the right control arm for the 2002-2003 Chevrolet Trailblazer?
Yes, Dorman 526-633 is the front left lower control arm for the 2002-2003 Chevrolet Trailblazer. Other vehicles are covered too; look yours up in the "Vehicles it fits" section.
Do I need to buy Dorman control arm bushings separately?
No. This assembly comes with the ball joint and the steel and rubber bushings already installed on the arm, so no separate bushings are needed.
What hardware comes with this Dorman control arm?
Dorman 526-633 includes one control arm, one ball joint and one nut, plus mounting hardware. A grease fitting is not included.
What size is the ball joint stud on this Dorman lower control arm?
The stud is threaded, with a 16 mm thread diameter and a 34.58 mm stud length. The ball joint uses a press-in mounting.
What can a worn front left lower control arm look or sound like?
A clunk over bumps, uneven tire wear or cracked bushing rubber can all be signs of wear. A shop can check the ball joint for play, so have a suspected problem looked at promptly.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.