Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS20486
Keep the front suspension tracking true with the Mevotech Supreme control arm CMS101600, a front left lower control arm and ball joint assembly that locates the wheel, cushions road inputs through its bushings, and carries the integrated ball joint that lets the steering knuckle pivot. It installs as a direct-fit replacement for the 2018-2021 Jaguar E-Pace, 2015-2019 Land Rover Discovery Sport, and 2017-2019 Land Rover Range Rover Evoque.
Built for high-usage passenger vehicles, SUVs, fleets and working trucks, this Mevotech Supreme lower control arm also folds in Labor Saver designs and hardware intended to speed up the job. Because it serves the front left lower corner, consider inspecting and replacing the opposite side for balanced handling, and have the wheel alignment checked after installation.
Interchange: 19471615 · 8CB10809 · J9C13932 · J9C2117 · LR060047 · LR086108 · LR096362 · LR115123 · LR117141 · GS101600 · 2608812 · X25CJ1103
This part cross-references / interchanges with the following part numbers:
What is the Mevotech Supreme suspension control arm CMS101600?
It is a front left lower control arm with an integrated ball joint. The arm locates the wheel and cushions road inputs through its bushings, while the ball joint lets the steering knuckle pivot.
Which vehicles does CMS101600 fit?
It is a direct-fit replacement for the 2018-2021 Jaguar E-Pace, 2015-2019 Land Rover Discovery Sport, and 2017-2019 Land Rover Range Rover Evoque. See the Buyer's Guide tab to confirm your engine and trim.
What position is this control arm for?
This unit is cataloged for the front left (driver-side) lower position. The right side uses a different part, so verify the corner you need before ordering.
What are signs this control arm may need replacing?
Clunking or knocking over bumps, uneven tire wear, or wandering steering can point to worn control arm bushings or a loose ball joint. If a failed arm is the cause, replacing it addresses those issues.
Do I need a wheel alignment after installing it?
Yes, replacing a control arm changes front suspension geometry, so have the wheel alignment checked and set after installation for correct tire wear and handling.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.