Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS861190
Mevotech Supreme CMS901317 front right lower control arm with ball joint for the 2017-2020 Genesis G80 and other vehicles connects the wheel assembly to the frame and lets the wheel pivot. Sold as a control arm and ball joint assembly, this Mevotech Supreme control arm includes the ball joint and rubber bushings.
A clunk over bumps, uneven tire wear or loose-feeling steering can mean this control arm or its ball joint is worn, though a worn tie rod end or wheel bearing can produce similar signs, so find the cause before you replace it. This listing is one arm for the front right; the front left is a separate part, since this position takes one arm on each side of the axle, and both sides are normally replaced together.
This control arm is a direct-fit replacement for the 2017-2020 Genesis G80 and the 2015-2016 Hyundai Genesis.
Fit and size
Build and materials
One control arm with ball joint, rubber bushings, dust boot, slotted castle nut and cotter pin.
Interchange: 54506B1500 · 2CB90499 · 2609650
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Mevotech Supreme CMS901317 right for a 2017-2020 Genesis G80?
Yes. The Mevotech Supreme CMS901317 fits the 2017-2020 Genesis G80 in the front right lower rearward position. A left-side arm is a separate part.
Does the Mevotech Supreme suspension control arm come with a castle nut and cotter pin?
Yes. The Mevotech Supreme CMS901317 includes a slotted castle nut and cotter pin, along with the ball joint, rubber bushings and dust boot.
Is the Mevotech Supreme lower control arm made of aluminum?
Yes. This lower control arm is aluminum, with rubber bushings and a rubber dust boot. Its ball joint has a threaded stud.
How do I tell if the ball joint on this control arm is worn?
A clunk over bumps, uneven tire wear or loose-feeling steering can be signs. A shop can check the ball joint and bushings for play.
How is the ball joint secured on this control arm?
The ball joint is secured to the vehicle with the part-specific slotted castle nut and cotter pin provided. The assembly comes pre-greased.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.