Front Sway Bar Bushing Kit for 2010-2011 Saab 9-5 - Delphi TD925W

$34.99
WARNING:California Proposition 65▾
Delphi Suspension Control Arm Bushing TD925W
Delphi Suspension Control Arm Bushing TD925W

Vehicles this part fits
    Part number: TD925W
    UPC: 689604297865
    Condition: New
    Weight: 0.30 LBS
    Item Package Quantity: 1
    $34.99
    Adding to cart… The item has been added

    Have questions?

    Ask an Expert
    Delphi Suspension Control Arm Bushing P/N:TD925W
    Delphi Suspension Control Arm Bushing P/N:TD925W
    $34.99
    $34.99

    Quiet the front-end rattle and keep your stabilizer bar firmly located with the Delphi Sway Bar Bushing Kit TD925W. It installs as a direct-fit front replacement on the 2010-2011 SAAB 9-5 (see the "Vehicles it fits" section for engine details), cradling the front stabilizer bar where it mounts so the bar can pivot and resist body roll through corners.

    Delphi applies its OE engineering to its aftermarket steering portfolio, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part. These bushings are validated hard: tested below -40°C and above 120°C and exposed to 720 hours of salt spray.

    • Designed to OE standards for a proper fit at the front stabilizer bar.
    • Built for consistent life and made to reduce noise.
    • Made to reduce vibration as the bar works.
    • Includes the necessary accessories for a complete job.

    Worn sway bar bushings often show up as clunking, knocking, or rattling from the front over uneven pavement and looser handling in turns; if failed front bushings are the cause, this kit replaces them.

    Interchange: 13281782 · V401387

    This part cross-references / interchanges with the following part numbers:

    13281782, V401387

    Frequently Asked Questions

    What does the Delphi TD925W do?

    It's a front sway bar bushing kit that cradles the stabilizer bar where it mounts, letting the bar pivot while it resists body roll. Worn bushings can allow clunks, rattles, and looser cornering.

    What vehicle does this kit fit?

    It's a direct-fit front replacement for the 2010-2011 SAAB 9-5. See the "Vehicles it fits" section for engine-level fitment details.

    Is this a front or rear part?

    It's a front application, serving the front stabilizer (sway) bar on the listed 2010-2011 Saab 9-5.

    Is this also known as a stabilizer bar bushing kit?

    Yes — it's the same component. The Delphi TD925W is cataloged under both that name and sway bar bushing kit.

    What numbers does this Delphi kit replace?

    It interchanges with 13281782 and V401387. Delphi also includes the necessary accessories for a complete installation.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review

    Related Products

    !