Delphi Suspension Control Arm P/N:TC7100
Locate the wheel and hold your front suspension geometry in line with the Delphi control arm TC6084, a front right lower forward suspension control arm built as a direct-fit replacement for the 2004-2006 Infiniti G35. Delphi applies its OE steering and suspension expertise to this aftermarket G35 control arm, extending part life and helping return worn, clunking, or loose front suspension back to a tight, controlled feel when a failed arm is the cause.
OE-validated engineering: Tested to the extreme for OE performance — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
100% inspection: Each arm undergoes full crack detection and ultrasonic flaw detection so the materials match OE specifications.
Robot-welded & precise: Robotic welding delivers consistent quality, and the ball studs are machined to micron tolerances for durability and smooth joint operation.
Anti-corrosion protection: A corrosion-resistant treatment is applied to each part for corrosion prevention and enhanced appearance.
This Infiniti G35 control arm fits the 2004-2006 Infiniti G35 — see the Buyer's Guide tab to confirm your exact vehicle.
Interchange: 54500-AL801 · 524-244
54500AL801 · 524244 · 1028047 · CA61094 · CA61094PR · RK642008 · RK642547 · CMS301023 · JTC2986 · JTC2987
This part cross-references / interchanges with the following part numbers:
What vehicle does the Delphi TC6084 control arm fit?
It is a direct-fit replacement for the 2004-2006 Infiniti G35. Check the Buyer's Guide tab to confirm it matches your exact vehicle and configuration.
What position is this control arm?
This is the front right lower forward suspension control arm. It replaces the original arm in that specific position on the listed G35 applications.
What are signs this control arm may need replacing?
Clunking or knocking over the front suspension, loose or wandering steering, uneven tire wear, or visibly cracked or worn bushings and ball joint can indicate a worn control arm.
How is this Delphi control arm built and protected?
It uses robot welding for consistent quality, ball studs machined to micron tolerances, 100% crack and ultrasonic flaw detection, and an anti-corrosion treatment on each part.
Should I replace the control arm on both sides?
Suspension components wear over similar mileage, so replacing the matching arm on the other side is a good practice for balanced handling. An alignment is recommended after installation.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.