Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4181W
$17.99
(You save)
Quiet the rattles and keep the front stabilizer bar located under body roll with the Delphi Suspension Stabilizer Bar Bushing Kit TD4181W. This kit is a direct-fit replacement for the front sway bar on the 2007-2012 Mazda 3 — see the Buyer's Guide tab for engine-level fitment. The stabilizer (sway) bar bushings cushion the bar where it mounts to the chassis, so a cracked, dried, or worn bushing is a common source of clunking or knocking over uneven pavement and looser body control in turns; if worn bushings are the cause, this kit replaces them.
Designed to OE standards: Delphi applies its OE steering and suspension expertise to this aftermarket kit for close compatibility with the original part.
Built for consistent life: manufactured for consistent performance and to help reduce noise as the bar works.
OE-grade validation: Delphi tests to the extreme — parts endure below -40°C and over 120°C plus 720 hours of salt spray, backed by extensive dimensional and material analysis.
Smoother ride: designed to help restore the vehicle's smooth ride.
Front position. Replacing both bushings together is recommended for balanced control.
This part cross-references / interchanges with the following part numbers:
K200675, B37F-34-156B, MS76849
Frequently Asked Questions
What vehicle does the Delphi TD4181W kit fit?
It is a direct-fit replacement for the front stabilizer bar bushings on the 2007-2012 Mazda 3. Check the Buyer's Guide tab for engine-level fitment before ordering.
Is this a front or rear sway bar bushing kit?
This is a front stabilizer bar bushing kit, matched to the front sway bar on the listed Mazda 3 applications.
What is a stabilizer bar bushing kit and what does it do?
It supplies the bushings that cushion the sway bar where it mounts to the chassis, helping locate the bar and reduce noise as it controls body roll in turns.
What are signs my front sway bar bushings may need replacing?
Clunking or knocking over bumps and looser body control in corners can point to cracked or worn bushings. Diagnose the cause first, since other suspension parts can produce similar symptoms.
Should I replace both bushings at once?
Yes, replacing both front bushings together is recommended for even, balanced control and consistent handling.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4181W
Suspension Stabilizer Bar Bushing KitDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests...
Quiet a clunking front sway bar and keep the front suspension composed with the Delphi Suspension Stabilizer Bar Bushing Kit TD4214W. These bushings mount the front stabilizer bar to the frame...
Quiet a clunking front sway bar and keep it located as it works with the Delphi Suspension Stabilizer Bar Bushing Kit TD790W. These front stabilizer bar bushings cushion the bar where it mounts to...
Quiet the clunks and rattles from a worn front stabilizer bar and keep the anti-roll system tied down tight with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4763W). It drops in as a...
Quiet down front-end rattle and keep the stabilizer bar located with the Delphi Suspension Stabilizer Bar Bushing Kit TD5760W. These front sway bar bushings cushion the bar where it mounts to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
