Cushion road impacts and keep the front end turning smoothly with the KYB strut mount kit SM5776, a front-position replacement for the 2010-2012 Hyundai Santa Fe and 2011-2013 Kia Sorento. This suspension strut mount kit replaces old, hardened vibration insulators so the strut assembly seats and pivots the way the factory intended — see the Buyer's Guide tab for engine-level fitment.
On the front axle, the bearing plates act as the steering pivots and support vehicle weight, making them critical to steering feel and wheel alignment. If a failed or hardened front strut mount is the cause of clunking over bumps, a stiff steering feel, or excess vibration, this kit replaces it. Inspect and service the mounts as a pair for balanced ride quality.
Interchange: 902037
This part cross-references / interchanges with the following part numbers:
What does the KYB strut mount kit SM5776 do?
It replaces the front strut mount and bearing, cushioning road impacts through the rubber isolator while the bearing serves as the steering pivot and supports vehicle weight.
Does this suspension strut mount kit fit my vehicle?
It is a front-position fit for the 2010-2012 Hyundai Santa Fe and 2011-2013 Kia Sorento. Check the Buyer's Guide tab to confirm your exact application.
Is this a front or rear strut mount?
This kit is cataloged for the FRONT position, where the bearing plates act as the steering pivots and support vehicle weight.
Does it include mounting hardware?
Yes. KYB supplies matched grade studs and nuts with the mount for proper installation.
What are signs my front strut mount may need replacing?
Clunking over bumps, stiff or notchy steering, and added noise or vibration can be signs of a worn or hardened mount. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
