Timken Engine Crankshaft Repair Sleeve P/N:88176
Timken 88187 front crankshaft repair sleeve for the 1975-1996 Ford F-150 V8 5.0L, the 1977-1996 F-150 V8 5.8L, the 1995-1996 F-150 6-cylinder 4.9L, the 1997-2003 F-150 V6 4.2L, the 1997-2010 F-150 V8 4.6L or 5.4L, the 2005-2008 F-150 V6 4.2L, the 2010-2011 F-150 V8 6.2L, the 2011 F-150 V8 5.0L, the 2011-2014 F-150 V6 3.7L, the 2011-2017 F-150 V6 3.5L and other vehicles gives a seal-worn shaft a fresh surface for the lip seal to ride on. Catalogs also list this Timken crankshaft repair sleeve as an engine crankshaft repair sleeve.
Oil seeping at the front crankshaft seal, or a groove worn into the shaft where the seal lip rides, can mean the sealing surface needs a sleeve. A worn seal, a damaged harmonic balancer or a leaking gasket nearby can show up the same way, so find the cause before buying. This listing is one sleeve, for the single seal surface at the front of the crankshaft.
As a front crankshaft repair sleeve, it also fits the 1982-1995 Ford Mustang V8 5.0L and the 1997-2004 Ford Expedition V8 4.6L. If your vehicle is not named here, look up your own year and engine in the "Vehicles it fits" section.
Fit and size
Build and materials
One crankshaft repair sleeve, with its removable installation flange and its own installation tool.
Product information is for general reference and may contain errors. See our Disclaimer.
Does this front crankshaft repair sleeve fit the 1997-2004 Ford Expedition V8 4.6L?
Yes. Timken 88187 is listed for the 1997-2004 Ford Expedition V8 4.6L. For any other year or engine, check the "Vehicles it fits" section.
Does the Timken 88187 sleeve come with an installation tool?
Yes. Each Timken 88187 sleeve comes with a removable installation flange and its own installation tool.
Is this front crankshaft repair sleeve made of steel?
Yes. This sleeve is a precision-engineered steel sleeve with a thin-walled design, so the seal size stays the same.
How can I tell the crankshaft sealing surface is worn?
A ring or groove worn into the shaft where the seal lip runs is a typical wear mark, and oil weeping at the front seal can go with it. A shop can inspect the shaft to confirm.
Do I have to machine the shaft before fitting the Timken 88187?
No. Timken 88187 needs no preparation or machining before mounting, and it goes on without pulling the shaft.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.