TrakMotive Drive Shaft Assembly P/N:FDP-004
TrakMotive FDP-003 rear drive shaft for the 1984-1990 Ford Bronco II carries driveline torque back to the rear axle.
A worn drive shaft can show up as vibration at speed, a clunk when you shift or accelerate, or grease thrown from the joints. Those signs alone do not prove the shaft is the problem, since an out-of-balance tire is another common source of vibration.
This is a 1984-1990 Ford Bronco II drive shaft, and that truck takes just one.
Fit and size
Build and materials
One drive shaft. CV joints and a grease fitting are not included.
Interchange: 65-9822 · 976-167
N98228 · E9TZ4602AF
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the rear drive shaft for a 1989 Ford Bronco II?
Yes. TrakMotive FDP-003 is a rear drive shaft for the 1984-1990 Ford Bronco II, which covers 1989, and the truck takes one.
Does this drive shaft assembly include the slip yoke and CV joints?
Yes for the slip yoke and no for CV joints. The TrakMotive FDP-003 includes the slip yoke, but CV joints are not included.
How long is the TrakMotive FDP-003 drive shaft and how wide is the tube?
Compressed length is 30.33 in (769.94 mm), and the shaft diameter is 2 in (51 mm). The tube is steel.
Could a clunk or vibration from the rear mean the drive shaft is worn?
Yes, it can. Vibration at speed, a clunk on shifting or accelerating, or grease around the joints can point to drive shaft wear, and a shop can inspect it to find the cause.
Does this rear drive shaft need greasing before it goes on?
No. This drive shaft comes pre-greased, and no grease fitting is included with it.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.