Walker Products Engine Variable Valve Timing (VVT) Solenoid P/N:590-1081
Walker Products 590-1118 VVT solenoid for the 2008-2011 Mitsubishi Lancer 4-cylinder 2.0L, the 2009-2010 Lancer 4-cylinder 2.4L and other vehicles controls camshaft timing by directing engine oil to the cam phaser. This variable valve timing solenoid is an OE replacement that lets valve timing follow engine load and speed.
A solenoid that clogs, sticks open or closed, or fails electrically can set timing fault codes such as P0010–P0014 or P0020–P0024, or bring rough idle, hesitation or reduced power. Low oil or a damaged connector can also set timing codes, so inspect the connector and wiring and check the oil level with the engine off and cool before replacing the solenoid.
This is a direct-fit replacement for the 2008-2011 Mitsubishi Lancer 4-cylinder 2.0L and the 2009-2010 Lancer 4-cylinder 2.4L, and it is also a VVT solenoid for the 2008-2010 Mitsubishi Outlander 4-cylinder 2.4L. Its electrical specs, oil flow rate and response timing are calibrated to match the original. Each engine takes one solenoid, on the intake side.
Fit and size
Build and materials
Interchange: 73-12122 · 916-896 · 190-050 · 35-1138
2T1122 · VV1140 · TS1122 · 2VTS0122 · 1028A021 · VVT240 · VTS1113
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Walker Products 590-1118 the right solenoid for the 2009-2010 Mitsubishi Lancer 4-cylinder 2.4L?
Yes. Walker Products 590-1118 fits the 2009-2010 Mitsubishi Lancer 4-cylinder 2.4L and is listed for the intake position.
What connector does this VVT solenoid have?
It has one black, rectangular female connector with two male terminals. The solenoid itself has a single mounting hole.
What is the housing of this VVT solenoid made of?
Metal. The housing is metal and is paired with oil-resistant seals.
Which fault codes can a failing VVT solenoid set?
A clogged, sticking or electrically failed solenoid can set codes in the P0010–P0014 and P0020–P0024 ranges. A shop can read the codes and test the circuit.
Does the Walker Products 590-1118 need any modification to install?
No. Walker Products 590-1118 uses the factory connector and mounting point, so no modification is required.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.