Walker Products Oxygen Sensor P/N:350-341076
Walker Products 350-34258 right oxygen sensor for the 2016-2023 Toyota Tacoma 4-cylinder 2.7L or V6 3.5L and other vehicles measures the oxygen in the exhaust gas. This Walker Products oxygen sensor is a 4-wire, direct-fit, narrow-band design that tracks combustion efficiency.
A failing sensor can show up as rough running, higher fuel consumption or a lit malfunction indicator light. With the engine off, look over the sensor, its wiring harness and the connector for physical damage; other faults can produce these symptoms too, so track down the cause before you replace the sensor.
This sensor fits the 2016-2023 Toyota Tacoma 4-cylinder 2.7L or V6 3.5L, the 2003-2004 Toyota Corolla 4-cylinder 1.8L and the 2003-2006 Toyota Matrix 4-cylinder 1.8L. This listing is one sensor, and the fitment calls for a quantity of one. If your car isn't named here, look it up in the "Vehicles it fits" section.
Fit and size
Build and materials
Interchange: CTK-OSTO4005
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the right Toyota Corolla oxygen sensor for a 2003-2004 Corolla 4-cylinder 1.8L?
Yes. Walker Products 350-34258 fits the 2003-2004 Toyota Corolla 4-cylinder 1.8L, and the fitment calls for a quantity of one.
Is this an oxygen sensor for a 2016-2023 Toyota Tacoma 4-cylinder 2.7L or V6 3.5L?
Yes. Walker Products 350-34258 is listed for the 2016-2023 Toyota Tacoma with either the 4-cylinder 2.7L or the V6 3.5L, one sensor per application.
What does this narrow-band oxygen sensor actually measure?
This sensor measures the amount of oxygen in the exhaust gas, which indicates combustion efficiency. It monitors the air-fuel ratio and gives the ECU the diagnostic feedback it needs.
What problems can a failing 4-wire oxygen sensor cause?
A failed sensor can make the engine run poorly, raise exhaust emissions or light the malfunction indicator light. Newer vehicles may also store a fault code in the ECU.
What is the coating on the Walker Products 350-34258 sensor for?
The coating protects the electrode surfaces from contamination and erosion by combustion residue and particulates in the exhaust gases. The electrodes use a gas-permeable platinum layer.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.