Anchor Engine Mount P/N:9135
Anchor 10294 right engine mount for the 2021-2026 Hyundai Elantra 4-cylinder 1.6L or 2.0L and other vehicles supports the engine and dampens vibration. Anchor engine mounts are designed to OE standards using CAD/CAM engineering, and this one is a hydraulic type.
A worn engine mount can show up as a clunk on acceleration, deceleration or shifting, vibration at idle, or cracked or separated rubber. Before you replace this mount, rule out other sources of the same noise or vibration, since other worn parts can produce them too.
This mount is listed for a wide range of Hyundai and Kia models, led by the 2021-2026 Hyundai Elantra 4-cylinder 1.6L or 2.0L, the 2024-2026 Hyundai Kona 4-cylinder 1.6L or 2.0L and the 2022-2026 Hyundai Elantra N 4-cylinder 2.0L. Each takes one mount in the right position, and the other side is ordered separately. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One right engine mount. Mounting hardware, a mounting bracket and a heat shield are not included, so plan on new bolts.
Interchange: 21810BE200 · 21810AA100
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will the Anchor 10294 Elantra N engine mount fit a 2022-2026 Hyundai Elantra N 4-cylinder 2.0L?
Yes. Anchor 10294 is listed for the 2022-2026 Hyundai Elantra N 4-cylinder 2.0L, and it is the mount for the right position.
Does this right engine mount come with bolts or a bracket?
No. This listing is one right engine mount; mounting hardware, a mounting bracket and a heat shield are not included, so plan on new bolts.
Is this Anchor motor mount hydraulic or solid rubber?
Anchor 10294 is a hydraulic mount, filled with special hydraulic fluid to dampen excess noise and vibration. The body is cast aluminum with a rubber bushing.
What size is the stud on this right engine mount?
The stud is M12-1.25 metric thread, with one stud on the mount. The three mounting holes are 13.3 mm (0.52 in) in diameter.
Why does my car clunk when I shift, and could a worn right engine mount be involved?
A clunk on acceleration, deceleration or shifting, vibration at idle, or cracked or separated rubber can be signs of a worn mount. A shop can confirm which mount, if any, is at fault.
Manufacturer's Warranty: 12 Month Warranty.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.