Autobest Fuel Pump Module Assembly P/N:F4731A
Autobest F2934A fuel pump module for the 1996 Chevrolet S10 4-cylinder 2.2L and other vehicles draws fuel from the tank and sends it toward the engine. The module combines the pump with a fuel sending unit and a fuel tank pressure sensor.
Hard starting, stalling, a whine from the tank or a fuel gauge that reads wrong can come from a failing fuel pump module, though other fuel-system faults cause the same signs. Before replacing it, look over the fuel pump fuse and relay and the harness connector for damage with the engine off.
This module is a direct-fit replacement for the 1996 Chevrolet S10 4-cylinder 2.2L, the 1996 GMC Sonoma 4-cylinder 2.2L and the 1996 Isuzu Hombre 4-cylinder 2.2L. A 1996 GMC Sonoma 4-cylinder 2.2L takes one module, and this listing is a single module.
Fit and size
Build and materials
One fuel pump module with a wire harness, strainer and gasket or seal. The fuel filter, regulator and mounting hardware are not included, so plan on new mounting hardware rather than reusing the old.
Interchange: 953-5015
MU10 · MU1781 · E3923M · P359M · 67332 · E3923MN · P74717M · FG0027 · 19179984 · 25163486 · EFP910M · EC923M · SP359M · 150068 · USEP3923M · TU405
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Autobest F2934A fuel pump module fit a 1996 GMC Sonoma 4-cylinder 2.2L?
Yes. Autobest F2934A is made for the 1996 GMC Sonoma 4-cylinder 2.2L, and that truck takes one module.
Does the Autobest F2934A come with the fuel filter or mounting hardware?
No. The fuel filter, regulator and mounting hardware are not included. Autobest F2934A comes with the pump, wire harness, strainer, sending unit and a gasket or seal.
What size are the fuel line connections on this fuel pump assembly?
Autobest F2934A has a 5/16 quick-connect inlet and a 3/8 quick-connect outlet, with one outlet in total.
How can I tell if this fuel pump module is going bad?
Hard starting, stalling, a whine from the tank or an odd fuel gauge reading can be signs. A shop can test pump pressure against the 72.5 to 101.5 PSI range.
What voltage and connector does this fuel pump module use?
It runs on 12V with a 7 A average current draw. The electrical connector is a rectangular male connector with four male pin terminals.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.