Keep your Hyundai Elantra control arm geometry tight and your rear suspension tracking true with the Beck/Arnley Suspension Control Arm 102-7230, a rear lower control arm engineered as a direct replacement for the 2007-2012 Hyundai Elantra. Beck/Arnley parts are built for Original Equipment applications across foreign nameplates, with close attention to form, fit and function, so this lower control arm for the Hyundai Elantra drops into the factory location and helps locate the wheel, connect the knuckle to the chassis, and maintain rear alignment through suspension travel.
Matches OE form, fit and function — application-specific for this vehicle.
Comes without a ball joint, which matches the OE design.
Steel, iron, or aluminum construction (varies by application) for durability and rust/corrosion resistance.
New hardware and bushings included where applicable.
Worn control arms or bushings often show up as clunking or knocking from the rear, uneven tire wear, or alignment that won't hold. If a failed rear lower arm or its bushings is the cause, this Elantra lower arm replaces it. For balanced handling, inspect the matching side and replace as directed by the service procedure.
What vehicle does the Beck/Arnley 102-7230 control arm fit?
It is a direct-fit rear lower control arm for the 2007-2012 Hyundai Elantra. See the Buyer's Guide tab to confirm the exact fit for your vehicle.
Does this control arm come with a ball joint?
No. This control arm comes without a ball joint, which matches the OE design for this application.
What is this lower control arm made of?
Construction is steel, iron, or aluminum depending on the application, chosen for durability and rust/corrosion resistance.
Are hardware and bushings included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any originals may be reused.
What are the signs a rear lower control arm may need replacing?
Clunking or knocking from the rear, uneven tire wear, and alignment that won't hold can point to a worn arm or bushings. Diagnose the cause before replacing.
Steer with confidence and quiet, controlled suspension travel using the Beck/Arnley Suspension Control Arm 102-6596 — a 350Z lower control arm that drops in as a direct-fit replacement for the...
Keep the rear suspension located and riding true with the Beck/Arnley control arm (P/N 102-8149), a rear lower forward control arm that drops in as an application-specific replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
