Keep your front stabilizer bar quiet and properly located with the Beck/Arnley Suspension Stabilizer Bar Bushing Kit (P/N 101-6503). This front stabilizer bushing set drops in as a direct replacement on the 2001-2004 Toyota Tundra — see the Buyer's Guide tab for engine-level fitment. Stabilizer bar bushings cushion the front sway bar where it mounts to the chassis, isolating it to limit noise and help control body roll; if worn, cracked, or oil-soaked bushings are the source of a clunk or rattle from the front, replacing them addresses that cause.
Inspect and replace the front stabilizer bushings as a set for balanced, quiet handling.
Interchange: 45G1495 · 1032452 · 60244046 · FA7614 · MK80818 · 5501495 · HB80818 · 48815AF021
This part cross-references / interchanges with the following part numbers:
What does this part fit?
It is a direct replacement for the 2001-2004 Toyota Tundra. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
Is this a front or rear part?
The catalog lists this as a FRONT stabilizer bar bushing kit.
What does a stabilizer bar bushing do?
It cushions the front sway bar where it mounts to the chassis, isolating it to limit noise and help control body roll during cornering.
What are signs these bushings may need replacing?
A clunk or rattle from the front, along with cracked, worn, or oil-soaked rubber, may indicate the bushings need replacing. Diagnose the cause before ordering.
What are the bushings made of?
They are made from a high grade rubber compound that resists heat, wear, salt, road grime, and oils, with quality construction for durability.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
