Quiet the rear-suspension rattle and keep body roll in check with the Beck/Arnley Suspension Stabilizer Bar Bushing Kit 101-7590. These bushings cushion the rear stabilizer (sway) bar where it mounts to the chassis, locating the bar and isolating it so it can resist body lean through turns. It installs as a direct-fit replacement for the 2004-2006 KIA Amanti — see the Buyer's Guide tab for engine-level detail.
Built to Beck/Arnley's OE form, fit and function for foreign-nameplate applications, so the set drops in like the factory bushings on the listed vehicle.
Worn, cracked, or hardened stabilizer bar bushings are a common source of clunks or rattles over bumps and increased body roll. If failed bushings are the cause, replacing them with this rear set helps restore proper stabilizer-bar control.
Interchange: 8400268 · 555773F100
This part cross-references / interchanges with the following part numbers:
What does this bushing kit do?
It cushions and locates the rear stabilizer (sway) bar where it mounts to the chassis, isolating it so the bar can resist body roll through turns.
Which vehicle does the 101-7590 fit?
It is a direct-fit replacement for the 2004-2006 Kia Amanti. Check the Buyer's Guide tab to confirm fitment for your vehicle.
Is this for the front or rear stabilizer bar?
This kit is cataloged for the REAR stabilizer bar bushings on the listed applications.
What are the signs my stabilizer bar bushings need replacing?
Clunks or rattles over bumps and increased body roll or lean in turns can indicate worn, cracked, or hardened bushings. Diagnose the cause before replacing.
What numbers does this part interchange with?
It cross-references the following numbers: 8400268 and 555773F100.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
