CARDONE New Disc Brake Caliper P/N:2C-2001
A1 CARDONE 2C-4927 rear right brake caliper for the 2005-2014 Ford Mustang presses the pads against the rotor to slow the wheel. The disc brake caliper is a new, unloaded floating design.
Signs of a failing caliper can include the car pulling to one side under braking, a wheel that drags, or fluid seepage around the caliper. Binding slide pins, a collapsed brake hose or a worn rotor can be behind these signs as well, so find out which is at fault before buying a caliper.
This caliper is a direct-fit component for the 2005-2014 Ford Mustang and is engineered to meet or exceed O.E. performance.
Fit and size
Build and materials
One caliper with its bracket, hardware kit, abutment clips, bleeder screw and instruction sheet. Brake pads and mounting bolts are not included, so plan on new mounting bolts. This listing is one rear right caliper and that side takes one; the rear left is a separate part ordered separately, and both sides are normally replaced together.
Interchange: 5R3Z2552AA · 7R3Z2552A · 8R3Z2552A · CR3Z2552B · CR3Z2552C · DR3Z2552A · DR3Z2552B · DR3Z2552C
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this rear right caliper the right one for the 2005-2014 Ford Mustang?
Yes. A1 CARDONE 2C-4927 is the rear right caliper for the 2005-2014 Ford Mustang. The rear left side is a separate part.
Is the mounting bracket included with this A1 CARDONE brake caliper?
Yes. The listing comes with the bracket, a hardware kit and an instruction sheet. Brake pads and mounting bolts are not included.
What size piston does the 2C-4927 caliper have?
A1 CARDONE 2C-4927 has one steel piston, 42.77 mm (1.68 in) in diameter, in a floating caliper with a banjo inlet fitting.
Can a sticking rear caliper make the car pull to one side when braking?
Yes, a caliper that sticks can make the car pull to one side under braking, among other possible sources. Brakes are a safety system, so have a pull inspected promptly.
What grease goes on the mounting pins of a floating caliper like this?
A silicone grease is used on floating caliper mounting pins. The instruction sheet that comes with this rear caliper covers the installation steps.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.