CARDONE New Disc Brake Caliper P/N:2C-2966
A1 CARDONE 2C-6026 rear right brake caliper for the 2009-2014 Acura TL squeezes the brake pads against the rotor to slow the car. It is a new, unloaded floating disc brake caliper built as a direct-fit component and engineered to meet or exceed O.E. performance.
A pull to one side under braking, a brake that drags or fluid around the caliper can mean a caliper is failing. A sticking slide pin or a restricted brake hose can also give a pull, so look those over during the same brake service.
Among the 2009-2014 Acura TL calipers, this one is for the rear right. The rear left is a separate caliper, and the two on the rear axle are normally done at the same time.
Fit and size
Build and materials
One unloaded rear right caliper with its bracket, a hardware kit, abutment clips, a bleeder screw and an instruction sheet. This listing holds one caliper, and the rear right takes one. Brake pads and mounting bolts are not included, so plan on new bolts rather than reusing the old ones.
Interchange: 43018TK4A00
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the A1 CARDONE 2C-6026 caliper fit the 2009-2014 Acura TL?
Yes. A1 CARDONE 2C-6026 is made for the rear right of the 2009-2014 Acura TL. The rear left side takes its own separate caliper.
Does this A1 CARDONE brake caliper come with a bracket and hardware?
Yes. A1 CARDONE 2C-6026 includes the bracket, a hardware kit, abutment clips, a bleeder screw and an instruction sheet. Brake pads and mounting bolts are not included.
What piston does this A1 CARDONE caliper use?
This rear caliper has a single steel piston, 38.15 mm (1.5 in) in diameter, in a floating design with a banjo inlet fitting.
Will replacing the rear right caliper stop my brakes from squealing?
Not necessarily. Squeal can come from improperly installed pads, improperly installed brake hardware or an improper rotor finish, so the caliper is not the only thing to look at.
What grease goes on the mounting pins of this floating caliper?
Silicone grease is used on floating caliper mounting pins. For brake fluid, use the type the car maker specifies, stamped on the master cylinder reservoir lid.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.