A1 CARDONE 30-2884MA distributor for the 1988-1991 Ford F-150 V8 5.8L and other vehicles sends voltage to the spark plugs in the correct timing pattern. This remanufactured A1 CARDONE distributor is an electronic type.
- All electronic module components are 100% computer tested for full functionality
- Components with consistently high failure rates are 100% replaced or repaired
- Precise machining tolerances help prevent oil leakage, poor timing and premature failure
- Automated test equipment checks signal strength, wire harness polarity, air gap, crank reluctor tooth size, and ignition coil and pickup performance
- 100% new points and condensers installed where applicable
Quick facts
- Part: A1 CARDONE 30-2884MA distributor
- Fits: 1988-1991 Ford F-150 V8 5.8L and other vehicles
- Material: Aluminum housing, steel shaft, cast iron gear
- Condition: Remanufactured
A worn distributor can show up as hard starting, a misfire or rough running. Before you replace the distributor, rule out worn spark plugs, plug wires, the cap and rotor and the ignition coil, since faults in those parts produce misfires and hard starting as well.
Fits
This distributor is listed for a wide range of Ford models, including the 1988-1991 Ford F-250 V8 5.8L and the 1988-1991 Ford Bronco V8 5.8L.
Specifications
Fit and size
- Quantity per vehicle: 1
- Shaft diameter: 13.46 mm (0.53 in)
- Shaft length: 297.18 mm (11.7 in)
- Length: 11.708 in
- Gear tooth quantity: 15
- Terminals: 6 male blade terminals
- Rotor rotation: clockwise
Build and materials
- Type: electronic, remanufactured
- Trigger type: Hall effect
- Vacuum advance: computer controlled
- Housing material: aluminum
- Shaft material: steel
- Gear material: cast iron
- Connector type: unsealed
- Slip collar: yes
- Country of origin: Mexico
In the box
One distributor and one instruction sheet. This listing holds one distributor, which is the number the vehicle needs. A distributor cap, ignition rotor and coil wire are not included.
Interchange: E7TE12127DA · E7TZ12127D
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Is this the right distributor for the 1988-1991 Ford F-150 V8 5.8L?
Yes. A1 CARDONE 30-2884MA is listed for the 1988-1991 Ford F-150 V8 5.8L and other Ford models. Open the "Vehicles it fits" section and look up your own truck or van there.
Can I use this distributor in the 1988-1991 Ford Bronco V8 5.8L?
Yes. A1 CARDONE 30-2884MA is listed for the 1988-1991 Ford Bronco V8 5.8L, and that engine takes one distributor.
Does this remanufactured distributor come with a cap and rotor?
No. The box holds the distributor and an instruction sheet. A distributor cap, ignition rotor and coil wire are not included.
Does the A1 CARDONE 30-2884MA use a Hall effect trigger?
Yes. It is an electronic distributor with a Hall effect trigger and computer-controlled vacuum advance. Its steel shaft is 13.46 mm (0.53 in) in diameter.
Does the Ford number E7TZ12127D match this A1 CARDONE distributor?
Yes. E7TZ12127D is listed as an interchange number for A1 CARDONE 30-2884MA, along with E7TE12127DA.
