Distributor for 1977-1978 Dodge Charger & More - A1 CARDONE 30-3850

$131.99

Vehicles this part fits

    Part number: 30-3850
    UPC: 082617030656
    Weight: 2.10 LBS
    Item Package Quantity: 1
    $131.99
    Adding to cart… The item has been added

    Have questions?

    CARDONE Reman Distributor P/N:30-3850
    CARDONE Reman Distributor P/N:30-3850
    $131.99
    $131.99

    A1 CARDONE 30-3850 distributor for the 1977-1978 Dodge Charger V8 5.2L or 5.9L and other vehicles sends voltage to the spark plugs in the correct timing pattern. This A1 CARDONE distributor is remanufactured to stringent quality standards.

    • Electronic module components are 100% computer tested for full functionality
    • Components with consistently high failure rates are 100% replaced or repaired
    • Precise machining tolerances guard against oil leakage, poor timing, a Check Engine light and premature failure
    • Automated test equipment verifies signal strength, wire harness polarity, air gap, crank reluctor tooth size, and ignition coil and pickup performance
    • New points and condensers installed where applicable

    Quick facts

    • Part: A1 CARDONE 30-3850 distributor
    • Fits: the 1977-1978 Dodge Charger V8 5.2L or 5.9L and other vehicles
    • Material: aluminum housing, steel shaft
    • Condition: Remanufactured

    A worn distributor can show up as hard starting, a misfire or rough running. These signs alone do not prove the distributor is at fault, since worn spark plugs can cause them too.

    Fits

    Listed for a wide range of Chrysler, Dodge and Plymouth models, this distributor includes the 1978-1979 Chrysler Town & Country V8 5.9L and the 1978-1981 Town & Country V8 5.2L, as well as the 1980 Plymouth Gran Fury V8 5.9L and the 1980-1989 Gran Fury V8 5.2L. The 1977-1978 Dodge Charger V8 5.2L or 5.9L takes one.

    Specifications

    Fit and size

    • Quantity per vehicle: 1
    • Shaft diameter: 12.62 mm (0.497 in)
    • Shaft length: 221.84 mm (8.734 in)
    • Length: 9.486 in
    • Terminals: 2, bullet type, male and female

    Build and materials

    • Type: electronic, with a magnetic coil trigger
    • Vacuum advance: computer controlled
    • Housing material: aluminum
    • Shaft material: steel
    • Slip collar: yes
    • Connector: unsealed
    • Condition: remanufactured
    • Country of origin: Mexico

    In the box

    One distributor and one instruction sheet. The distributor cap, ignition rotor and coil wire are not included.

    Interchange: 4049140 · 4091140 · 4091142

    Product information is for general reference and may contain errors. See our Disclaimer.

    This part cross-references / interchanges with the following part numbers:

    4049140, 4091140, 4091142

    Frequently Asked Questions

    Will this Charger distributor fit the 1977-1978 Dodge Charger V8 5.2L or 5.9L?

    Yes. A1 CARDONE 30-3850 is listed for the 1977-1978 Dodge Charger V8 5.2L or 5.9L, one per car. If your car is another model, look it up in the "Vehicles it fits" section.

    Does the A1 CARDONE 30-3850 come with a distributor cap and rotor?

    No. The box holds the remanufactured distributor and an instruction sheet. The distributor cap, ignition rotor and coil wire are not included.

    What size is the shaft on this remanufactured distributor?

    The distributor shaft is steel, 12.62 mm (0.497 in) in diameter and 221.84 mm (8.734 in) long.

    How can I tell if an electronic distributor like this is wearing out?

    Hard starting, a misfire or rough running can be signs. With the engine off and cool, you can look at the housing for cracks or oil leaks; a shop can test the ignition signal.

    Does 4091140 interchange with this A1 CARDONE distributor?

    Yes. 4091140 is listed as an interchange number for A1 CARDONE 30-3850, along with 4049140 and 4091142.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review